| ||||||||||||||||||||||||||
| ![]() | ![]() | |||||||
| SoundSplinter How are you using your RL-p15?Discuss How are you using your RL-p15? in the DIY Speakers and Subwoofers forum; How are you using your RL-p15? I'm curious how many people are using their RL-p15s in sealed, ported, IB, or other types of enclosures. Feel free ... |
| View Poll Results: How are you using your RL-p15 | |||
| Sealed | | 2 | 7.41% |
| Ported | | 19 | 70.37% |
| IB | | 4 | 14.81% |
| Other (please specify) | | 2 | 7.41% |
| Voters: 27. You may not vote on this poll | |||
|
| | Thread Tools |
| | #1 (Link) | |||
| How are you using your RL-p15? I'm curious how many people are using their RL-p15s in sealed, ported, IB, or other types of enclosures. Feel free to post specifics about yours, but I thought a poll would be a good way to get info from lots of people, since they wouldn't be forced to write a whole post. There seem to be a lot of big ported enclosures, but I wonder if that's actually what most people are using, or if those people are the ones who tend to brag the most about their subwoofers. ![]() | |||
|
| | |
| | |
| | #2 (Link) | |||
| Re: How are you using your RL-p15? Four RL-P15's in an IB manifold driven by an EP2500.... flat to 10Hz (can't measure below that with my equipment), measured 120db + at 15 feet... too scary to go beyond that www.garagehobbies.com/ib.aspx | |||
|
| | #4 (Link) | |||
| Re: How are you using your RL-p15? While my IB is quite impressive in output it is small in comparison to some ![]() My setup will displace 16 liters of air, I think my house resonant frequency is somewhere around 12Hz if the walls moving are any indication! | |||
|
| | #17 (Link) | |||
| Re: How are you using your RL-p15? I'm in the club now! Two in an IB. | |||
|
| | #19 (Link) | |||
| Re: How are you using your RL-p15? Ported all the way Heres an unpainted pic so you can see it. It has since been painted with a high gloss black and against my black walls I cant get any good pictures of it now.![]() ![]() Last edited by Jerm357; 01-25-08 at 07:07 PM. | |||
|
| | #20 (Link) | |||
| Re: How are you using your RL-p15? Dual RLP 15" 2 ohm DVC with 4 15" passive radiators loaded to 1100 grams each. Re-wired all 4 coils to series wiring, 8 ohms to amp, QSC 1450 bridged to mono. Performs great. Plan to start on another just like it now that I've got a spare QSC amp. Crisp clean lows with the passives. Low volumes or high. ![]() Last edited by Mike Cason; 01-25-08 at 07:33 AM. | |||
|
| | #21 (Link) | |||
| Re: How are you using your RL-p15? Joining the Sound Splinter club,very soon. RLp 15 in a 13cu ft box,15Hz tuning ...8" port flared to 10" . Next...a second one. In a 800cu ft room,backed by a dozen other subs. ![]() | |||
|