Velodyne SPL-1200 MK2 *new*

[Ilkka]

Manufacturer: Velodyne
Model: SPL-1200 MK2
Provided by: Bumer
Manufacturer link: Velodyne (replaced by SPL-1200R)
Price: 1550 EUR, 1499 USD

Manufacturer specs:
• Driver: 12” forward firing (9.7” piston diameter), Kevlar reinforced Resin Cone, 3” dual layer voice coil, inner/outer wound, die-cast aluminum basket
• Amplifier: 2000 watts Dynamic/1000 watts RMS Power
• High Pass Crossover: 80Hz (6 dB/octave)
• Low Pass Crossover: 40Hz-120Hz or bypass for Subwoofer Direct, 12 dB octave initial, 48 dB octave ultimate
• Frequency Response: 22-120Hz
• Magnet Structure: 346 oz. (21.6 lbs.)
• Inputs: Gold plated RCA line and speaker level inputs
• Outputs: Line-level 80Hz up
• Phase Control: 0 or 180 degrees
• Video Shielded: Yes
• Dimensions (H/W/D): (inc. feet & grill) 14.75” x 14.25” x 16.375”, (37 x 36 x 41 cm)
• Cabinet: Sealed enclosure
• Warranty (parts/labor): Two years
• Weight (approx.): 57 lbs. (26Kg)

Configuration as tested:
Phase: 0 degrees
Crossover: Bypassed
Orientation: Woofer facing the mic

[Ilkka]

+/- 3 dB points: 22 Hz - 64 Hz (crossover min)

+/- 3 dB points: 23 Hz - 90 Hz (crossover max)

[Ilkka]

[Ilkka]

[Ilkka]

reserved

[arande2]

Ewwww

[Jason Schultz]

MMMM For what these cost I prefer a DIY definatly

[rbartyczak]

Ten years ago this would have been very impressive. In today's arena, it is looking very mediocre but at a premium price.

[doubeleive]

it looks pretty anyway but not the design I prefer, if it were a little taller and ported under the bottom front would probably be a keeper