 |
 | |||||
 |  |  |  | ||
 |  |  |  | ||
 |  |  |  | ||
| ||||||||||||||||||||||
|  |  | |||||||
| Welcome | Member Introduction First PostDiscuss First Post in the General Shack Area forum; First Post Hi
I'm new to this forum. I recently acquired a Denon 4308, a nice piece of furmiture to house my ...  |
  |
|
Views: 213 - Replies: 11
| Thread Tools |
 02-16-09, 03:37 PM
| #1 | ||||
| First Post Hi I'm new to this forum. I recently acquired a Denon 4308, a nice piece of furmiture to house my equipment, a Panasonic Plasma, S100 speakers from Paradigm and a Sub 13Ultra from SVS. I just finished calibrating everything with Audyssey. I have some puzzles to solve, like how to select which curve in Audyssey....how to change a bit the Audyssey selections....etc. Regards  | ||||
  |
 Advertisement | |
| |   |
| 02-16-09, 03:43 PM
| #2 | ||||
| Re: First Post Welcome to the Shack! Andrew | ||||
| |
| 02-16-09, 03:44 PM
| #3 | ||||
| Re: First Post Hi Horace, great to have you here. With the Denon, use the on screen interface and set the EQ to Audyssey. You can individually change the settings (cut off freq, etc). It won't defeat the Audyssey settings, just alter them to your tastes. Have fun. Dennis L Dennis Doan, DC Gonstead Chiropractor IT'S THE NERVE!  www.drdoan.com www.healedthefilm.com SVSound SBS-01 fronts, center, rear surrounds (I was honored to be the 1st purchaser of these great speakers) Klipsch RS-42 side surrounds SVSound SB12-Plus/2 sub (w/12.3 drivers) AS-EQ1 Sub Equalizer (WOW!) Denon AVR-2807 Receiver w/AudysseyXT Toshiba DVD Recorder w/HDMI Direct TV DVR HD BenQ W5000 projector mounted on ceiling. 91" MovieTime pull-down screen 15' x 11.8' vaulted ceiling dedicated HT room w/DIY sound absorption:  | ||||
| |
| 02-16-09, 03:56 PM
| #4 | ||||
| Re: First Post Hi Dr Doan Thanks for the advice on how to tweak the Audyssey. I find the Subwoofer setting somewhat low with Audyssey. So, I calibrated with the Sub Gain around 11 o'clock and moved the gain to 12 o'oclock. It sound right this way. The organ notes sound full bodied. Thanks to your suggestion, I will apply corrections sometimes. Some films have a weak front speaker, (especially translations) others are weak in Bass. I have printed the Audyssey settings so as to revert to the original. Regards..... | ||||
| |
| 02-16-09, 03:57 PM
| #5 | ||||
| Welcome to Home Theater Shack! Howdy qhp310 and welcome to the Shack! Help yourself and enjoy your stay... Sonnie   | ||||
| |
| 02-16-09, 04:02 PM
| #6 | ||||
| Re: First Post During the Audyssey set up procedure, you can save the settings. These will remain until you reset them, even if the power is lost for a while. (at least it is on my Denon). Dennis L Dennis Doan, DC Gonstead Chiropractor IT'S THE NERVE! www.drdoan.com www.healedthefilm.com SVSound SBS-01 fronts, center, rear surrounds (I was honored to be the 1st purchaser of these great speakers) Klipsch RS-42 side surrounds SVSound SB12-Plus/2 sub (w/12.3 drivers) AS-EQ1 Sub Equalizer (WOW!) Denon AVR-2807 Receiver w/AudysseyXT Toshiba DVD Recorder w/HDMI Direct TV DVR HD BenQ W5000 projector mounted on ceiling. 91" MovieTime pull-down screen 15' x 11.8' vaulted ceiling dedicated HT room w/DIY sound absorption: | ||||
| |
| 02-16-09, 04:10 PM
| #7 | ||||
| Re: First Post Welcome to the forum...  Enjoy your system | ||||
| |
| 02-16-09, 04:19 PM
| #8 | ||||
| Re: First Post Welcome Horace! Good to have you here! | ||||
| |
| 02-16-09, 04:22 PM
| #9 | ||||
| Re: First Post Welcome to the Shack! | ||||
| |
| 02-17-09, 06:20 PM
| #11 | ||||
| Re: First Post Hi With the Sub Gain raised to 12 o'clock, the Bass is ok. I changed the balance between the 2 surround speakers. I realised, I have no Surronds B!!!! Only Surrounds A!!! I copied the curve to Audio....not sure if it works. Before my last measurement, I read posts on Audyssey. I decided to shut the furnace off!!!! That helped! I could not acheive a flat LF curve before, with my Radio Shack Sound Meter and the PEQ on the SVS Sub: it just did not seem to work. Maybe on account of the furnace Low Frequency rumble? Now, with Audyssey, I don't realy need the PEQ. Besides, the PEQ takes measurement from one location only whereas Audyssey averages the listening area (8 locations). And the PEQ takes much more time (manually). Regards | ||||
| |
