Home Theater Forum and Systems - HomeTheaterShack.com - Reply to Topic

Thread: Getting the upgrade itch Reply to Thread
Title:
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now




PLEASE COMPLETE ALL REQUIRED FIELDS BELOW... THANKS!

REQUIRED FIELDS ON THIS PAGE
YOU MUST COMPLETE ALL OF THESE

Username
Password
Confirm Password
Email Address
Confirm Email Address
Random Question
Random Question #2




User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
PLEASE READ BELOW PRIOR TO ENTERING AN EMAIL ADDRESS!

ATTENTION!

YOU MUST ACTIVATE YOUR ACCOUNT!

Activation requires you reply to an email we will send you after you register... if you do not reply to this email, you will not be able to view certain areas of the forum or certain images... nor will you be able download software.

AN INVALID EMAIL ADDRESS WILL CAUSE YOUR ACCOUNT TO BE DELETED!

See our banned email list here: Banned Email List

We DO NOT respond to spamcop, boxtrapper and spamblocker emails... please add @hometheatershack DOT com to your whitelist prior to registering or you will get nowhere on your registration.


Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
01-18-17 10:52 PM
fusseli
Re: Getting the upgrade itch

Sorry for the extra long delay, I just noticed your post!

It looks like 4cuft sealed, with lots of fill, would take over 1000W, so two on 1400W would be amp limited without worry of bottoming the subs. You could go even bigger. 2cuft is tiny for this sub and would probably be intended for car audio.
11-13-16 11:02 PM
splatee
Getting the upgrade itch

Hello,

It's been awhile since I have posted on here but I have been reading a lot. I built awhile back 2 x 12 inch soundsplinter diy subs powered by a tapco j1400. I have a build thread on here somewhere.

I am thinking about doing a new build using the following drivers

RE Audio SEX15D4 15 inch subwoofers.

Fs = 31.53 Hz
Qms = 6.094
VAS = 2.527 cu.ft
Xmax = 21mm
Sd = 127 sq.in
Qes = 0.839
Le = 1.273 mH
Re = 1.384 ohms
Z = 1.66 ohms
Pe = 750 watts

I would like to build two sealed boxes. RE audio shows them to need 2.0 cu.ft for sealed.

Could someone model these in a sealed box. I would wire them both to 4 ohm load feeding them 1400 watts bridged.

Thank you

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML is not allowed!

 


For the best viewing experience please update your browser to Google Chrome