Home Theater Forum and Systems banner

1/4"

  1. Using active PA sub with an AV receiver

    System Setup and Connection
    Hello, I was planning on plugging in an 18 inch enforcer 1200 watt rms sub to my Sony av receiver. The inputs on the sub are 1/4" and the sub out on the receiver is a female RCA jack. Is there a cable that goes from an RCA jack to a 1/4" jack? Also my other question would be that do you think...
  2. 1/4" shank roundover bits

    DIY Speakers
    Looking at the picture bellow it becomes apparent that a large diameter roundover is crucial to speakers' smooth response in the upper range. Now the problem is that I have a 1/4" router and as hard as I've been looking I could not find a roundover bit with radius larger than 1/2". I was...
  3. DSP2411p - XLR or 1/4" to RCA?

    Electronic Processing/Equalization Devices
    Hi Folks, Got a DSP2411p and an ECM8000 (plus behringer mic pre=amp) on its way. I will be connecting the DSP2411p between a Velodyne Sub and a Rotel RSP1069 processor (RCA inputs/outputs). What would be the better connection type, XLR-RCA or 1/4" to RCA? Or does it even make a difference...
Top