Home Theater Forum and Systems banner
Cancel

Search Results for ‘20db’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results

Search Tags

1080p 2007 2008 2009 2010 3d 4k advice amp april audio bass behringer blu-ray bluray box build calibration camera card center channel coming dayton denon design digital diy dual eq game giveaway good hd hdmi hdtv high home ht input issue issues lcd level listings live march measurement measurements member mic mitsubishi needed newbie october onkyo panasonic pioneer player post power prime problem problems programming project projector ps3 question receiver releases reported response review rew room samsung screen season series setting setup sony sound soundcard spl subs svs system test theater thread time toshiba tv ultra upgrade video wall xbox
  1. AV Home Theater
    I have an Anthem mrx520 powering my 5.2 setup. When listening to movies at -20db the speakers sounded fine but was worried to drive my 4ohm speakers any harder using the integrated amp. I just added an ATI525NC class D amp which is 300wpc into 4ohms and switched the connection to my Anthem...
    20db adding louder make preamp system
  2. Audio Processing
    A few days back I REW(ed) by SVS Pb-13ultra. Only Subwoofer was measured. The subwoofer response shocked me. I didn't realize that there has been a big dip like this in my HT My question is that Audyssey is capable of fixing this dip? or if the response curve steeper than -3dB (as pointed...
    20db 40hz audyssey compensate dip huge
  3. Audio Processing
    Good evening all , i installed my anthem mrx300 today and calibrated with ARC. My sub is a DIY LMS-R15 with Behringer ep4000. AS you can see on the graph i have a 20db drop from 40 to 100 What is the best way to cure that dip???? I do not have a lot of option to move the sub which is...
    20db arc dip showing
  4. REW Forum
    When I run REW on my Dell laptop I use the microphone in and headphone out jacks because that is all there is on this model. I get useful traces (and was able to make huge improvement in my system using them) but despite following the calibration instructions to set to 75db and turning my...
    20db calibration off?
  5. REW Forum
    Hi, I have managed to measure the frequency response of my PB12+/2 using REW and in my room, the response is pretty bad with a very strong bias towards the low end of the spectrum (20hz to 45hz) and I have quite a big dip at 53hz - cross-over is set at 80hz. My rectangle-shaped room is pretty...
    10db 20db dip peak
1-5 of 5 Results
Top