Home Theater Forum and Systems banner
6000dsp
1-4 of 4 Results
  1. Subwoofer Amps | High Pass Filters
    Hello folks, I've just ordered two subwoofer combos from Parts Express (18" Dayton HO driver and the knock-down 4 ft^3 enclosure). I'd like to run it with an Inuke 6000DSP. As you can probably tell, I'm very new to this. I'm clueless regarding pro-audio stuff. What confuses me is I...
  2. DIY Subwoofers - General Discussion
    I just pre ordered 2 si d2 18s plan on getting diysoundgroup flat packs and the 6000dsp. Ive done a lot of research and would like some help with making these sound the best they can. My room is 13x24x8 and is open to the kitchen in the rear as well as 2 open doorways. Any help would be much...
  3. Subwoofer Amps | High Pass Filters
    Hi I am looking for suggestions on replacement fans for the Inuke 6000DSP. This is what I have found so far but am a little unsure if the CFM is ok or too low. http://www.overclockers.co.uk/showproduct.php?prodid=FG-022-BQ&groupid=701&catid=2331&subcat=819 Dimensions: 80 x 80 x 25 mm...
  4. Subwoofer Amps | High Pass Filters
    I use a Behringer iNuke 6000DSP to drive my DIY-sub. (one channel) How should I determine the values for the limiter? (Hold and Release) I also would like to determine the Vp (peak Voltage) The limiter is set at 128V for this driver (Monacor 18") The Behringer software says this is 1000W at 8Ω...
1-4 of 4 Results
Top