Home Theater Forum and Systems banner

adjustment

  1. Sub Timing/Phase Adjustment Procedure

    Home Audio Subwoofers
    First off, I'm not even sure I need to ask the questions that appear below. I think the purpose of time-aligning a sub is to smooth out the frequency response in the crossover region. I also think that auto EQ like Audyssey and Dirac do this for you. But if using REW, I think it's a manual...
  2. 50hdx82 convergence adjustment in service mode

    Toshiba
    Hello, I have been working on my 50hdx82 set for awhile now. I installed new IC chips from that I got from a online supplier and had my hyper module rebuilt with no success in getting the set up and running. Instead of spending time troubleshooting what went wrong with the repairs I went ahead...
  3. Projector ceiling mounts with smooth adjustment?

    Home Theater Projectors
    Are there any mounts out there with some fine-level, smooth adjustments? Tilt, side/side, maybe up/down? I have a PJ without lens shift, and the mount I have now is very clunky. If I need a quarter inch, its usually "THWUMP"....then way too much....its very frustrating. I've thought about...
  4. Convergence adjustment TIPS (on JVC X70)

    Home Theater Projectors
    I have some questions about setting my convergence perfect on my JVC RS55. First of all, why is there a pixel adjustment menu in the service menu of the RS55? Is it the intention to FIRST set it about as perfect as possible here and only AFTER this fine-tune it in the actual menu settings of the...
  5. is phase adjustment possible with BFD1124P?

    Electronic Processing/Equalization Devices
    Is it possible to adjust phase or delay in BFD1124P? if not, are there any cheap stand alone devices that can do this and, ideally, set HPF? I am trying to play with Geddes multisub technique and my supplemental subs only have 0/180 phase switch. thank you
  6. Question? Subwoofer Adjustment:

    Home Theater Receivers | Processors | Amps
    Hello, After I have connected my powered subwoofer to 2 floor standing 6 ohms speakers and to my Onkyo NR509 receiver. Would someone help me get the Best Subwoofer Performance? Not Positioning just adjustment. How do I adjust the: Crossover, volume, and Phase (not sure what these words mean)...
  7. Osage Reviews...THE ADJUSTMENT BUREAU (Blu-ray; Universal)

    Movies | TV Shows | Hollywood
    Releasing Studio: Universal Disc/Transfer Specifications: 1080p 1.85:1; Region 1 (U.S.) Release Video Codec: VC-1 Tested Audio Track: English DTS-HD Master Audio 5.1 Rating: PG-13 Director: George Nolfi Starring Cast: Matt Damon, Emily Blunt, Anthony Mackie OSAGE'S PLOT ANALYSIS: In a...
  8. The Adjustment Bureau - Blu-Ray Review

    Official DVD and Blu-ray Reviews
    http://www.hometheatershack.com/gallery/file.php?n=6849&w=lTitle: The Adjustment Bureau Starring: Matt Damon, Emily Blunt Directed by: George Nolfi Written by: George Nolfi (Screenplay), Phillip K. Dick (Novel) Studio: Universal Rated: PG-13 Runtime: 106 min Release Date: 6/21/2011 (Blu-Ray)...
  9. TP55D80 convergence adjustment

    Toshiba
    Just joined this forum, I sure like the info here. You guys are doing a great job. Anyway, my question is...I had the convergence IC's replaced and have the board back in the set. Now, I can adjust all direction, red and blue, but..The top right and the bottom left seem to be curved in. also...
  10. Focus adjustment part oracle hd-800 projector

    Home Theater Projectors
    Hi, I have just purchased a 2nd hand Oracle HD-800 LCD projector and found that the attachment to the lense is missing. This means I cannot focus the image onto my screen - it is just blurry. I have looked on the web for the oracle website, found it, and I cannot get any contact numbers to...
  11. Question on measurement and filter adjustment

    REW Forum
    First time to use REW. Setup is EMU0404 USB, DSP1124P to power amp driving a pair of HSU TN1220. I have attached the measurement before and after EQ. Measurement was done directly from EMU0404. One channel (R) out is fed to both channels of DSP1124P, then to a stereo power AMP driving 1 sub on...
  12. Horizontal Width Adjustment - 51F500A

    Hitachi
    Several months ago I successfully completed the convergence repair on my Hitachi 51F500A. I did the grid adjustments to correct the convergence to an acceptable level without using a template (by eye). One thing that has remained however is the picture is too wide and I don't know how to adjust...
  13. Toshiba 50H72 Convergence Adjustment in Service Menu

    Toshiba
    I just replaced two STK 392-110 chips in Toshiba 50H72 and it fixed the problem. I'd like to know what would be the best way to adjust convergence in service menu. Do all the lines must be perpendicular and square in convergence menu? Would it be a good idea to use Laser level to get all the...
  14. Service Menu Adjustment Question...

    Video Calibration
    Hi all, First, let me state that I am in no way an authority where this is concerned, so maybe it's the height of stupidity that I should even try. Here's the problem: my HD picture needs a slight adjustment in vertical position (Mitsubishi WS-65511). I have made a few slight adjustments to the...
  15. Audio Adjustment presets for Onkyo TXsr606

    System Setup and Connection
    I too am a newbe to this forum but I've heard that it's the best so here goes the question(s). I recently updated my home theater system (out with the Technic equipment and in with Onkyo) a few weeks ago. I kept the 5.1 Technic speakers and the sub woofer, as they were still in great shape and...
  16. pb13 ultra adjustment

    SVSound
    Just to play around, I turned on the crossover on the sub and lowered it to around 90 ish to see if any change in sound. Slight change, seems a little tighter, with more emphasis on the lower stuff. I will have to listen to a variety of music and movies to see. Most advice I have read was NOT to...
  17. Behringer FBQ2496 manual adjustment with RTA

    Electronic Processing/Equalization Devices
    Hello morning there. Okay I’ll cut straight the chase shall I? I have an RTA analyzer a basic model that has range from 25Hz 40Hz 63Hz 100Hz 160Hz 250Hz 500Hz 1 KHz 2 KHz 4 KHz 8 KHz 16 KHz. I’m using this with Behringer ECM8000 microphone and M100 preamplifier. Sub bass is an 18” JBL...
  18. NEED HELP: Filter Adjustment

    REW Forum
    I tried couple of hours to adjust filters but didn't have a good result of flattening the measurement. Can anyone here help me on this?:hail::hail::hail: It really making mad and tiring..:duh::duh::dizzy::dizzy::dizzy: My measurement file can be downloaded from here.
  19. Sanyo lens shift adjustment

    Home Theater Projectors
    Could someone explain how the vertical and horizontal lens adjustment on a projector like the Sanyo Z works? I've looked over the manual and it isn't clear to me how the range of motion operates, can the pictures position be adjusted anywhere from point a to b of the adjustment ark?
  20. 2 sub phase adjustment

    Home Audio Acoustics
    How do I detemine the proper phase adjustment of my two pb10s ?
Top