Home Theater Forum and Systems banner

alpine

  1. DIY Subwoofers - General Discussion
    For home theater subwoofer use alpine bass line 12 4.50 cubic feet tuned to 24 hz? My nephew wanted a alpine bass line since they were only 60 bucks shipped. Vas 64.3 fs 30 qts 49 xmax 10 mm
  2. DIY Subwoofers - General Discussion
    Hi all, Long time lurker, first time poster! I've recently got into Home theater, and now have a pretty good (for me at least) setup... except my sub! I have spent the past few months reading up on design, and learning how to use WinISD. After going through a lot of posts and a lot of drivers...
  3. Mobile Audio
    hey guys, any users of the alpine imprint ? i have a CDA-9887R with the imprint tunning kit i have ran it a few times and got some good sound from my setup just want to know if anyone has any tips for better sound do you really need to messure from 6 places? i have done 6 places but find 3...
  4. DIY Subwoofers - General Discussion
    Hey guys! I’m wanting to turn one of my car subs into a home sub just for music and movies. I was wondering what’s the best way to go about this? I don’t have a box for the sub so I guess id have to get one made from someone off of craigslist. What kind of specs should it have or anything...
  5. DIY Subwoofers - General Discussion
    Guys, I just finished my box in my SUV that contains 8 Alpine SWS-10D2 subs in a sealed box (all 3/4" MDF) with a solid divider sepatrating them into 4 subs on each side inside the box. My net volume per sub is .72 cubic feet per driver. here is a link to Alpine's specs for the sub...
  6. Ported Subwoofer Build Projects
    Hi, tomorrow i want build LLT subwoofer with Alpine SWR-1542D in 275Litres vented, tuned to 16,5Hz. Amplifier is American Audio V3000plus with 960W rms/2ohm. I use Behringer DSP1124p.Later i want to make the second sub with same speaker and enclosure and hook it to the second channel of...
  7. DIY Speakers
    Hello, I have two component sets that i would like to use at home. First is the Hertz HV165XL (6.5inch component set). Secondly i have a Alpine Type R SPR-17S (6.5inch component set). I have tried to model it in the Win ISD but i cannot find enough information to make it work right. I would...
  8. DIY Subwoofers - General Discussion
    Pretty much narrowed it down to these two drivers (12 inch), to pair with a BASH 300 for my first build. They model quite similarly, with the Alpine about 2 db up across the spectrum. Anyone with thoughts on sound quality? The car audio sites / feedback seems to favor the RE, but not sure how...
  9. Mobile Audio
    This is the story of my first fiberglass project ever... many years ago. The End! Any Questions, Comments, let me know! :T
  10. DIY Subwoofers - General Discussion
    Continue toying around with a variety of relatively inexpensive (<$200) 12-15" drivers and came across the Alpine SWR 1522.....seems to model quite well in about 5 cu ft tuned at 20hz. Similar to Mach 5 IXL 15...few DB more spl acorss the board than CSS trio or TC epic 12....anyone have...
  11. DIY Subwoofers - General Discussion
    So i've been puttzin around on here for a bit with different threads on which subs to use for a small sealed box. Well i want to use the Alpine type x 12". WINISD for some reason doesn't work on my laptop and was hopeing someone could model it for me, the sub is a dual 4ohm (all i know about it...
  12. Mobile Audio
    Alright, got my batteries, subs, sub amps, wires, terminal rings, HU, and crossover all figured out. Already have my highs/mids/amps. Working on an HT as well, looking to go surround 6.1 or 7.1 with 21" Maelstrom-X's as well, MTM with Kevin's Anarchy cheap tweet crossover. May get an HDTV...
  13. Mobile Audio
    Hey guys, I think there are more Alpine HUs that can run the PXA-H701, but here's the list I'm working off: CDA-9887 good HU 4 volt outputs only $270 if I don't want to play DVDs...great buy All the DVDs only have 2 volt rather than 4 volt. I know most think it doesnt matter..whatever. Price...
  14. Mobile Audio
    Anyone own any of these? Can I get 4 bandpassed outputs with it? I need 3 -way active... 2 outs for tweets HP, 2 outs for 4" BP, and 2 outs for 6.5" BP.... most crossovers only have 2 HP, 2BP, 2LP.... but I need FOUR bandpassed. Anyone selling any? Crutchfield says discontinued...
Top