Home Theater Forum and Systems banner

amp

  1. what amp for 200 watt rms pyle bl1290 sealed home theater subwoofer

    DIY Subwoofers - General Discussion
    I plan on going 4.00 cf gross for the pyle sub sealed this gives it a center frequency of about 35 hz and a -3 at 27 hz. We could even stuff it for an even lower center frequency and lower qtc than 1.10. The subwoofer is dual 4 ohm so we would need a amp at 200 rms at 8 ohms. Any suggestions...
  2. IB318 modelling and amp power

    IB - Infinite Baffle Subwoofer Build Projects
    Not sure If im modelling this correctly. This is telling me that I'd have to go up to 600W per speaker to hit Xmax. I've read in other places that 250-350w would be the most you'd want to go with dual opposed IB318 subs to prevent from bottoming out.
  3. Single amp to power front 3 and an IB?

    Home Theater Receivers | Processors | Amps
    Hello, As a neat solution I am looking at a custom 5 channel power amp to power the front 3 speakers in my setup, and an IB which I will install. The amp would be a 5 x 300 watt power amp. This gives me 2 channels with which to power the IB with. Does anyone have any thoughts as to if they...
  4. Fi car audio ht3 amp?

    Subwoofer Amps | High Pass Filters
    I'm looking to build 2 sealed enclosures with the Fi audio HT3. About 6^3 foot boxes haven't decided on which ohms to go with yet 2 or 4. Having a hard time finding an amp to run these. I'm in Canada. 90%movies 10%music Was looking at a crown but a lot of people say they are terrible for subs...
  5. Need Part # Of Amp on/off switch

    DIY Repair and Maintenance
    Hi Guys, I am trying to determine the part Number for the On/Off Switch for my Buttkicker BKA-130 amp. I have the schematic and found the on/off switch in there but the number there does not seem to be associated with any switches I have looked for.. So here is the schematic for the BKA-130...
  6. Denon X3300W and Ext amp issue

    Home Theater Receivers | Processors | Amps
    I am having a problem trying to hook up a ext amp to Zone 2 for stereo listening. I have the Denon set for 7 channel with front height and everything souns great. When I add a ext amp to zone 2 on another set of speakers it comes through as distorted like a blown speaker. The amp id a Carver...
  7. Newb needs help with subwoofer amp

    Home Theater Receivers | Processors | Amps
    Hi everyone. I recently replaced an old RCA home theatre in a box with a new Yamaha RX-V385BL receiver. I didn't know anything about the difference between passive and active subwoofers, but have since learned the receiver has only an RCA pre-out connection. My old RTD150 subwoofer is a...
  8. No Receiver just an amp

    AV Home Theater
    Hello I have a LG 4k tv upstairs that the sound is lacking so i bought klipsch quintet set that I plan on using only the front 3 speakers. I have a reciever I can use but would rather not. I am wondering if there is a simple amp I can run from the TV to power the speakers? I only have experience...
  9. Need a replacement amp

    Subwoofer Amps | High Pass Filters
    Well it’s been awhile and I’ve finally moved into a house with a basement. My old set up was using a behringer EP2500 but one of the channels went bad. I was also pairing it up with a behringer ultra gain pro for Hi/Lo pass filters. Was looking at Inuke 3000dsp, but I had a couple of questions...
  10. Polk Audio RTIA9 with receiver Yamaha Rx-v579. Need power. Amp possible?

    Home Theater Receivers | Processors | Amps
    Hello Home Theatre Shack! I recently came upon a crazy sale on Polk Audio RTIA9 speakers. I bought two. I knew about the crazy power requirement but thought I could attach a emotiva amp to help, but now I'm not so sure.(reciever is a Yamaha Rx-v579, 80w/channel) There are two preouts on the back...
  11. Elemental Designs A7S-450 LT1300 Amp Died??

    Home Audio Subwoofers
    hey guys. I haven't been here in a loooooong time. anyway, nice to be back but I need some help. I have an ED A7S-450 sub...it's worked for many years, however, now the light on the amp is on but no sound coming from the sub. I have a feeling the amplifier burned out inside somewhere. I...
  12. better amp to choose

    Home Theater System Recommendations
    hi hi can anybody tell me if anyone has tested both the marantz 7010 and denon 4300 using the dali zensor speaker package and can tell me what is the better amp for sound quality which is the better performer overall i have been told that dali speakers suit warmer amps overall so maybe more...
  13. Help with AVR Amp Assign

    Home Theater Receivers | Processors | Amps
    Sorry for this newbie question. Can someone please tell me definitively if the Marantz SR7012 has the ability to assign 8 of its 9 internal amplifiers to 4 surrounds and four height channels? I am upgrading to Dolby Atmos and will utilize a 7.2.4 configuration. I own an Emotiva XPA-3 which will...
  14. best speakers to use with amp

    Home Theater System Recommendations
    hi if i was to use the marantz pm6006 with the denon 4300 using dali zensor 7 as the fronts and dali ikon 6 mk2 dali vokal centre and two zensor 1 as additional rears and 4 dali aldico c1 atmos upfiring modules what speakers would you connect to the marantz pm6006 and the rest to the denon...
  15. Need amp recommendations for JL Audio 12W7AE

    Home Theater System Recommendations
    Hello I just needed recommendations for an amplifier. I was getting ready to sell it, but decided I might end up keeping it for home theater use. I have it in a ported box tuned to JL specs. The whole 3 ohm thing is making it difficult to find an amp, all of the ones I have seen only go down to...
  16. Sub amp replacement ???

    Subwoofer Amps | High Pass Filters
    Good afternoon all! I have two stereo integrity 15"d4 I believe they are rated around 900w a piece. I had been using the behringer ep4000 until my dog decided to use it as a fire hydrant. It did not survive! I am looking at the inuke. Should I get the NU4-6000 or the NU-6000. Drivers are in...
  17. amp that will work well together

    Home Theater System Recommendations
    hi my friend is after buying a q acoustics speaker package 2 q acoustics 3050 front speakers 2 q acoustics 3020 rear speakers q acoustics 3090c centre speaker he does not have the internet witch is why i asking for him my question he wants the very best amp 7.2 that does atmos dts-x that will...
  18. Crown I-tech HD amp fan mod not possible

    Two Channel Audio
    My crown I-tech 4x3500HD amp is installed in a server rack in my living room and its too noisy. The fans on this amp run constantly (this is normal on these amps) and spool up and down as needed (no error with their operation) The amp has two fans, the one that cools the amplifier modules is a...
  19. Run 50W speaker with a 350W amp: how to avoid break everything

    Pro Audio
    Dear experts, I’ve a question about amplifier and speaker. I would amp a 50W RMS 4 Ohm speaker with a 350W amp (Crown 1000) I understand that amplifiers have to be bigger than speakers, but my concern here is how to get the maximum output from this set up without destroying everything. I have...
  20. Two channel amp

    Home Theater Receivers | Processors | Amps
    Looking for an inexpensive but good 2 channel amp to run two height speakers for a 7.1.4 setup. I'm getting a Sony STR-ZA5000ES 9.2-channel AV Receiver to replace a Sony STR-DA5300ES 7.1-channel AV Receiver due to Ins. from DirecTV. I have a Klipsch speaker setup except two 6 inch ceiling...
Top