Home Theater Forum and Systems banner
amp
41-59 of 500 Results
  1. Home Theater Receivers | Processors | Amps
    I saw this and thought it was interesting. I didn't even know Mono-Price was getting into this area of audio. Talk on AK say's it is made for MP by ATI. Looks nice for the price...
  2. DIY Repair and Maintenance
    Hi Everyone, My Akai amp is only playing sound in one channel switched the speaker around still same thing, I checked the fuses and one has blown out. Can anyone help me identifying the fault? Shall I jut replace the fuse and try it back? The components look fine by eye. I am not an expert but...
  3. DIY Subwoofers - General Discussion
    I have a Bash 300 from PE running on my DIY ported sub, and I'm about done with the constant hum. It increases with the gain, so I either have little to no bass because the gain is so low, or I get bass plus the hum - which cannot be unheard once heard. Is there a decent subwoofer amp...
  4. AV Home Theater
    Just Amazing Sound and Power .... Wow very very clean. But do you guys think the top of the Denon can hold 90lbs ? Thx Also to have a old booklet and a New booklet Signed by B.K. Himself thx you so much Butler Audio is Truly Amazing !
  5. AV Home Theater
    When downstairs last night to put in a movie and both my amps where off I have an XPR-2 and a XPA-5. The five cut on with no issues but the XPR-2 clicked on and then off. I tried to cut it on several times and the same thing happened. The XPR-2 run my two tower speakers and they where off as...
  6. Subwoofer Amps | High Pass Filters
    Hoping this is the right place for this question. Looking for a little input from any of the forum sub gurus on wiring a dual voice coil (4 ohm each) sub to a two channel amp. The amp is not bridgeable and will muster 400 watts per channel at 4 ohms. What I'd like to do is wire this so that...
  7. Home Theater Receivers | Processors | Amps
    Hey, whats up? I have this Behringer nu3000dsp amplifer and a 1500 RMS 8ohm dual rockville pa speaker. This amp has a feature that you can select which load or ohms you want for the speaker. My question is. Is it okay to connet the speaker and run it in 4ohm mode? Would this damage the amp or...
  8. Home Theater Receivers | Processors | Amps
    I am looking for a 5 channel power amp to be hooked up with my Denon 2808 receiver. I would use it to power B&W 620's and I have a B&W HTM62 center with the 686's in the rear. I am looking for more power to push the fronts and get the most out of them. My price point is no more than $1,500. I...
  9. Two Channel Audio
    Hello All - I want to build a modest 2.1 channel stereo system for a guitar room. The amps I am considering are: Rotel RA-1570, and the Yamaha A-S801. The must haves are digital/optical inputs and would like a built in DAC. I will be connecting a Sonos Connect and a CD player. The primary music...
  10. DIY Speakers
    Hope I am asking in the right area if not my apologies. I have currently one MBM with a Dayton 465 the enclosure is fine but to me the amp could be better. As of now I am using a nu 3000DSP its a great amp for the money but compared to my sub amp it just does not cut it. My goal is to get a...
  11. Home Theater Receivers | Processors | Amps
    So I'll just let the rabbit out now... Purchased my showcase 7 12/14 and got it up and running 1/15. This entire year I've used it and it's worked out pretty good... no issues. Except that around 6 months after ownership I had one channel go bad.... so I moved to another and it lasted about 3...
  12. System Setup and Connection
    I currently am using a Pioneer Elite VSX-23TXH to power a 5.1 speaker system. The speakers are all DIY and the entire front soundstage has an approximate impedance of 4-ohms (which the receiver is not recommended to drive). I have a Dayton APA150 amplifier I would like to use to to power only...
  13. Home Theater, Audio and Video News
    With one of the industry’s most eye-catching cabinet designs, Power Sound Audio’s three-sided tri-woofer subsonic hammer, the T18HT, is getting a reboot. I recently spoke with Tom Vodhanel of PSA to discuss what’s new with their flagship product. The T18HT subwoofer is a more powerful...
  14. General Service and Technical Information
    Hello everyone! New member here and I'm looking for some advice. It would seem that after less than a year my NXG sub has bit the dust. Long story short, the manufacturer wont help me, and amazon cant help me. I know the problem is with the plate amp that came with it, it was notorious for...
  15. System Setup and Connection
    Hello, i have what i hope is a quick question, i am using a minidsp to change the phase of one channel, the amp i am doing this is a onkyo M-504, the thing i forgot is the channel that has the phase shifted , is that the new negative or positive, I would normaly use the calibration mic that my...
  16. Subwoofer Amps | High Pass Filters
    I'm looking to buy a amp to replace my Dayton SA-1000... Why you ask... well because I'm considering going with dual sealed subs (HST-15's) and my Dayton is a mono amp. Here is what I'm looking for. 1. Quiet 2. Lots of power 3. RCA inputs & speaker wire connections if possible I've looked at...
  17. System Setup and Connection
    Hi, I'm looking at building a DIY sub (lilwrecker) and not sure if I would take a plate amp (quite expensive and not a good option as I will need to build an external box for it anyway) or a PA amp (Behringer EP4000 or Crown XLS) I only don't really see how to connect the PA amp to my receiver...
  18. Home Theater System Recommendations
    Hello Shacksters, I've been absent from the forums for the past few months. I'm back and looking for input/opinions about what surround amp I should go with. I've narrowed it down to two very different animals. First is the all powerful Emotiva XPA-5. It's strong, it's big, and it's going...
  19. Classifieds - Audio Equipment
    I have three Behringer EP2000 amplifiers that I am selling. I purchased all of them new from Parts Express in May 2015, and performed the Digikey fan mod as described here: http://www.hometheatershack.com/forums/subwoofer-amps-high-pass-filters/23528-behringer-ep4000-pics-fan-mod-etc.html. The...
41-59 of 500 Results
Top