Home Theater Forum and Systems banner

amplifier

  1. System Setup and Connection
    Hi all, any help would be much appreciated Ok, I have a Pioneer VSK-922k amplifier and a Pioneer SSP-LX03 subwoofer I am having trouble connecting these together? On the back of the subwoofer it has the normal black / red cable wire connection port but on the back of the amplifier, it has a...
  2. Home Theater Receivers | Processors | Amps
    Hi, Back in 2014, I bought an LG BH9430PW 1460W 3D Blu-ray Theater System when it was first released. It is a powerful home theater system but had a lot of issues with its amplifier and rear speakers controller. Now I'm left with working speakers and I was wondering if I can buy a good and...
  3. AV Home Theater
    hi can anybody please tell me is the yamaha rx 3060 a class d amplifier if it is not i need a top end class d amp that does dolby atmos dts x that will work with the best of its ability with the klipsh 280f speakers thanks
  4. Home Theater System Recommendations
    Long time reader, first time poster. I cannot tell you how much I have appreciated this forum for my home theater. I have learned so much! That being said, I have a question. I want to replace my Emotiva Amplifier. Why? Well it makes a slight hum. Before you say it.. I have checked the...
  5. REW Forum
    Although I had successfully measured amplifer distortion at the loundspeaker terminals, when I did this a second time I managed to damage my inbuilt PC sound card. I was not using a voltage divider probe since I knew the AC levels were no more than 250mV. I don't fully understand what went...
  6. Home Theater System Recommendations
    Would adding an external AMP to my HT system be a good up-grade? Would it intensify the Movie viewing experience? Looking at the Emotiva 5 or 7 ch amp.
  7. Home Theater Receivers | Processors | Amps
    Curious if there is a amplifier with a built in DSP that can be adjusted manually via WiFi or Bluetooth? Looking to use this for a 2 channel system. I know there are ones that automatically do this but that isn’t always what my ears like to hear. Ultimately looking for a amplifier with a couple...
  8. DIY Audio
    This amplifier is based on a type of tube not usually considered for audio amplifiers such as this one from TI:http://www.kynix.com/Detail/99290/TPA2012D2%20EVM.html. Instead of using a typical audio preamplifier tube and then an appropriate power stage, this amp uses one of the vertical...
  9. Home Theater Receivers | Processors | Amps
    I am planing to assemble a 5.1 channel amplifier. I selected the famous TDA2030 as the basic element and is simple to proceed. But I have a confusion, whether to use some other Class D amplifier for better quality. Please share your experience about these classes of amplifiers in the term of...
  10. Home Theater System Recommendations
    hi i have decided to go with denon 720w reciever 6 dayton audio br-1 $210 a pair from philarmonic audio 2 jbl studio 550p subs 4 monoprice caliber in ceiling speakers 8 in way pioneer mtm c22 centre speaker my question is i want a very good need a four - five way power amplifier to...
  11. DIY Audio
    Hello all, I have a mono amplifier board and i want to combine it with any other multi channel amplifier to make it as 4.1......likewise in which i wanna use monoamp for my passive subwoofer(12 inch car subwoofer driver to use in home) is there any way to do that or any other way to get this...
  12. System Setup and Connection
    Hello! I am very new to all of this; just got my own place after graduating. I bought a set of samsung speakers (5 speakers + subwoofer) from a second hand store about two years ago pretty cheap with a mind to use them once I got where I am now. Yesterday I found a pioneer receiver at a local...
  13. Home Theater System Recommendations
    I am planing to assemble a 5.1 channel amplifier. I selected the famous TDA2030(this one) as the basic element and is simple to proceed. But I have a confusion, whether to use some other Class D amplifier for better quality.Conceptually, a Class D amplifier is considered by some music purists to...
  14. CD Players | Turntables
    I have a great new Denon sound system for my TV. But I would like to hear my old LPs, CDs, and Cassetteson my Denon powered system of sound around speakers. I prefer wires to wireless. But I don't know which jacks to connect to on the Denon or from which jacks on the back of my Sony...
  15. REW Forum
    Can I plot amplifier frequency using Room Equalization Wizard? It seems to be a microphone based application. I would need to go about the process differently for accurate measurements.
  16. Two Channel Audio
    Marantz's new Reference 2-channel integrated amp PM-10 and the matching SA-10 SACD/CD player will be on display and demonstrated in our 2-channel showroom demo area. They are scheduled to be available early February and Marantz will have a launch promotion on the pair with special pricing...
  17. Home Theater, Audio and Video News
    This is one of the best times of the year to buy home theater gear. Not only do we benefit from natural price reductions on aging 2016 models, but we also have access to massive deals on Black Friday and Cyber Monday. It just so happens that the fine folks at Power Sound Audio are jumping the...
  18. Home Theater Receivers | Processors | Amps
    Hello, I have an Onkyo TX-NR636. I am looking for suggestions on adding an amplifier to increase was audio quality. I just bought a second subwoofer(Klipsch R-10SW - Yet to be installed) - I realize I need to buy a new receiver at some point. I have Dolby Set-up, below is a list of my current...
  19. Home Theater Receivers | Processors | Amps
    Hi, I have a simple question, for example if i need 150W power to drive my speakers in real usage and my AVR is capable of delivering only 100W and if add extra 100W power amplifier , would it give 150W power or only power from the power amplifier will be used?. or i have now 200W in total? Thanks
  20. Classifieds - Audio Equipment
    I am selling 3 perfect physical and functional condition Behringer EP2000 units, just over a year old. I purchased them new from Parts Express in May 2015. The fans in these units run loud, and since I used the amps at relatively low power in my home theater only, I performed the Digikey fan mod...
Top