Home Theater Forum and Systems banner
amps?
1-8 of 8 Results
  1. Home Theater Receivers | Processors | Amps
    Can we really hear a difference between two amps? More specifically... between two amps that have been level matched in a controlled listening test. We are not talking about amps that have been modified or are driven beyond their reasonable limits. What a crazy and completely worn out...
  2. Subwoofer Amps | High Pass Filters
    I am looking for 500W x 2 channel at 4 ohms.. I am just browsing for more options besides the behringer EP series. Well actually wanted auto power on or 12V trigger but.. this doesn't have it also. Anyway I think the Yamahas look like they are built pretty nice and from what I read no need...
  3. System Setup and Connection
    I have hooked up 2 cv900 amps to Onkyo 805 receiver thru preouts do i still have 130w plus 210w ch of amp power or does the Onkyo internal amps shutdown. Leaving 210w ch total? It would be nice to know, If anyone can help thanks!
  4. Subwoofer Amps | High Pass Filters
    Hi, I am looking for a 1000, 1500 or 2000W (into 4 Ohms) plate amp for some projects I am musing over. If you want 500W it seems there is plenty of choice but get to a 1000W I can only find Dayton and they seem quite limited connectivity wise. I also have no idea of the quality either... Maybe...
  5. Subwoofer Amps | High Pass Filters
    Hello, A friend of mine recommended I post this question here, as he believes the level of knowledge is a little higher than where I originally had it. I am looking for a cheaper amp with a similar spec to the Behringer EP2500 and I think I have found one. The Pyle PZR6XA is available...
  6. System Setup and Connection
    Is there a way to share the same set of speakers between two different amps without having to physically disconnect and reconnect them each time? I'm talking about the main front speakers in an HT system only. For 2-channel, I would like to connect the same pair to a different amp, but without...
  7. Home Theater Receivers | Processors | Amps
    Looking at either a QSC RMX 1850HD or a QSC RMX 1450 to power my one Mal-X sub in a 16cf box tuned to 15hz. Are these amps powerful enough and does anyone have experience with either of these amp or QSC in general. I have used crown but wanted to try something new. :praying: Is there a better...
  8. Two Channel Audio
    I have four MA-500 monoblock amps that I using to power four 12" Crystal Audio & Video drivers. They drivers are rated 4ohm and up to 400W, but the amp they came with was a 200W RMS. The monoblocks I drive them are 180W into a 4 ohm load. This might be a silly question but do I loose or gain...
1-8 of 8 Results
Top