Hello
I use REW 5.16 and I've got a problem, when I make a new measurement I don't have the button " change cal.." in the measurement panel,,,, is there an issue ?
thanx a lot
I know theoretically I can apply a filter to whatever frequency I like but I have read that I should really try to apply filters to the lower frequencies. I cannot recall the exact reason for this. Assuming this is still sound advice, for practical purposes, what is the highest frequency I...
I am sure this has been discussed and asked....and I am also sure that it may not be the most accurate method, but I will ask.
Is it a good idea to take REW measurements from several locations across the main seating area and extrapolate the AVERAGE via REW, and than use that AVERAGED graph to...
Thanks to everyone's help I was able to have REW automatically apply and transfer a 4 point adjusted graph to my DSP1124P. I have been searching and can't figure out how to get the data in REW to have a "house curve" applied to my room. I found this interesting article, but still can't figure...
Hi, I was wondering if it is possible to permanently apply the sound card and microphone calibration files to the measured response; this would probably speed up the graph calculation, and also you would just have the *measured response* after the mic and sound card responses were canceled...
Here's my situation. I used REW and BFD to EQ a set of subs and got reasonably good results. When I add the main speakers to the mix and re-measure the response, the interaction of the mains with the subs throws the curve out of whack. My thought is that for movies this isn't a big deal...
Di you have to have the MIDI to configure the BFD, I was reading through the documents and the BFD docs here say once you set the levels head on over to the REW section and start taking measurements, then the REW section talks about applying the filters by sending them to the BFD via the MIDI...
I was wondering if it is ok to apply a gain of 6db at 3 frequencies.
I will be able to get a much flatter response if I apply higher gain like
5-6 db so that when I apply the cuts, the suck outs dont go further down.
I generally dont play very loud. With my volume setting I only measured some...
Recently I did another session of REW.
Until that moment, I had quite a flat respons, but was not overall happy. There was something missing.
When I started again, I tried something else.
In stead of solving almost every bump in the respons, I've applied some smoothing and only focussed on the...
Sonnie. Bruce et all. Hope things are well.. I have applied my first filter. woo-hoo. I applied a nice easy -3db cut at 20HZ with a Bandwidth of 5 (still dont understand BW fully, but it doesnt matter for the purposes of this) . Stored it and retested with rat shack meter. 16 hz was slightly...