Home Theater Forum and Systems banner
auto
1-19 of 52 Results
  1. Electronic Processing/Equalization Devices
    I have always wondered why all (at least the ones I have played with Audyssey, MCCAC YPAO) the auto calibration software seems to only run a single pass per channel? Yes I know some of them will allow you to adjust the position of the mic and run multiple passes but that is not what I am...
  2. Home Theater Projectors
    Hi, A few weeks ago my epson projector, just over night when i left it on, decided it didn't want to work anymore and had an auto iris fault. I checked online and saw that the local repair centre was 3 hours away with £400 fees with no guarantee on fixing it so I thought id try repair it myself...
  3. HDTV | Video Displays | Processors
    On your TV Do you have auto motion plus turned on or off
  4. System Setup and Connection
    I have a powered sub, Polk PSW10 connected to my Onkyo Sr-535 with a standard subwoofer cable, not a y-sub cable. I was told to turn the Low Pass all the way to 150 to essentially create an LFE. I then placed my Sub into Auto On. On my receiver, after doing the auto calibration, the...
  5. REW Forum
    In working with REW for two years now, I find the auto EQ feature is not very good. I get far better results by manually running sweeps and tweaking my MiniDSP EQ's based on the REW results. A lot of trial and error but the auto EQ just doesn't even come close. And I often get strange auto EQ...
  6. Home Theater System Recommendations
    Have noticed a trend in talking with friends & HT guys online about the auto calibration on the receivers. Quite a few of them aren't setting the crossover points anywhere near where they're supposed to be. Was helping a guy find a replacement Klipsch driver for his sub (don't ever set your sub...
  7. REW Forum
    I am using REW to help tune my bi-amped JBL horn setup. I have a MiniDSP 2x4 so have the options to use up to 6 Bi-Quads. I am getting as far as running the "Match Response to Target" but I am just trying to understand how REW is picking the center frequencies, Qs and amplitudes of the 6...
  8. Subwoofer Amps | High Pass Filters
    sorry if this has been asked before, i've searched but have come up empty... are you guys aware of any of the pro amps that feature an auto on function? seems like a trivial feature, but it is rather necessary in an installation i'm considering. thanks for any suggestions, scott
  9. Home Audio Speakers
    Hello, I wanted to reach out for some help to some seasoned DIY audio people. I have several 5" Monoprice powered monitors paired up with apple airport express' for a makeshift multi room system. It works perfectly as each book shelf speaker is independently powered for each small room, but...
  10. DIY Audio
    Hello, I wanted to reach out for some help to some seasoned DIY audio people. I have several 5" Monoprice powered monitors paired up with apple airport express' for a makeshift multi room system. It works perfectly as each book shelf speaker is independently powered for each small room, but...
  11. Home Theater Projectors
    My Epson Home Cinema 8350 is a little over a year old and now every time I turn it on it makes a clicking noises few about 2 second then it stops. I found a YouTube video with same grinding noise. Am about 99% sure my auto iris is off, will check when I get home. Anyone know what it is and...
  12. General Service and Technical Information
    My Epson Home Cinema 8350 is a little over a year old and now every time I turn it on it makes a clicking noises few about 2 second then it stops. I found a YouTube video with same grinding noise. Am about 99% sure my auto iris is off, will check when I get home. Anyone know what it is and...
  13. SPL Meters | Mic's | Calibration | Sound Cards
    Hi, This is my first post. I have recently purchased a svs pb12plus and wish to measure its inroom frequency response with rew. My spl meter does not have analogue output. Will the denon auto setup mic give me a ballpark frequency through my mic input on my laptop. Thanks
  14. REW Forum
    Does the Auto EQ function setup filters differently for average room spl responses vs say a single room spl response? When I enter an average mlp response for main speakers into auto eq the suggested filters do not fully reflect what is required to correct response to get me close to target...
  15. Video Game Systems | Video Games
    Grand Theft Auto 5 reaches worldwide retail sales of more than $1 billion in three days Take-Two today announced that Grand Theft Auto 5 has achieved worldwide retail sales of more than $1 billion during its first three days on sale. This is according to internal...
  16. REW Forum
    Hi- Can someone explain not what these settings are for, but how one would set them up for a particular situation? I am using a Pioneer AVR crossed at 80 hz. A mini DSP for sub eq. It appears REW, under the target settings, wants you to shape the same settings your AVR would be sending out...
  17. Video Game Systems | Video Games
    Grand Theft Auto 5 PC petition attracts 200,000 signatures A petition asking Rockstar to release a PC version of Grand Theft Auto 5 is gaining momentum. At time of writing, 208,641 gamers had indicated their support for the GTA 5 port, with 91,359 more needed before the...
  18. Home Theater Projectors
    My 1 1/2 year old Epson 8350 has and Auto Iris Error which to date has occured maybe 8 times and each time I have had to unplug the projector for a few minutes to get it to work. Anyone have this problem? I believe I have like 1400hrs on it. Why does unplugging the unit make it work again its...
  19. Home Theater Receivers | Processors | Amps
    in your receivers? In my case with Elite VSX-30, I find my "ALC" forces full band width with dynamics all still there but with a more controlled and tonally deeper response/auditory experience. I'm using a "Flat" response target with advanced MCACC. Just curious, and i'm using with TV watching...
1-19 of 52 Results
Top