I would like to ask a general question about room correction:
What shall be the ideal order of the followings:
- Room correction EQ
- Speaker distance setting
- Level setting
- Crossover setting
Currently the order I have is the following: Crossover -> Distance -> Level -> EQ
But I was...
I need help in calculating my gain chain in my active speaker system: this is what I want to achieve
- remove the hiss problem
- be sure that with the pre-amp turn to max I will not blow out my drivers
- be sure I'm doing the right things...
this is my system
- Marantz SR7002...
Title: Chain of Command
HTS Overall Score:67
Let’s get this out of the way first. I...
Let's see if we can get a YouTube Music Chain going.
Give the Artist - Song Title and include the YouTube link. Remember to keep it clean and within the forum rules.
The song title must include at least one word of the previous song title.
For example, if the first song were to be Del...
Recently I went to see a few movies at "Studio Movie Grill" where you eat a full meal and watch a movie. Also, when you buy the ticket, you select which seat you want to sit. This way, no matter if late or not, you have your seat and since all the seats are reserved, you know there will not be...
It's been discussed that maintaining a list of sound card/mic pre/mixer/mic options might be valuable, including any pros and cons or notes on use. To kick it off, please post your REW signal chain components (not including cables) and what operating system you are using.
Here's my current...
It may seem like a dumb question...but all of the help files say to "plug the soundcard into itself", with the its output going to its input.
However, my mic pre (GT Brick) is a huge part of my signal chain. I plug my ecm8000 into it and THEN it goes to my soundcard (EMU 0404 PCI). So I decided...
OK, here is my setup. Onkyo TX-SR806 AVR w/Audyssey MultEQ (Dynamic EQ), Klipsch RF-82 (dual 8" woofer) towers - bi-amped because I'm only runing 5.1, Klipsch (12"/350 Watt) RW-12d sub and matching Klipsch center & surrounds. I am now going to add a BFD. I am using REW w/RS SPL meter.
I have two vga monitors, and no money to buy a new one. I have a computer with an asus M2A - which has video out of vga, dvi-d, and hdmi. I've done a little research and found that vga to dvi-d 'adapters' cost upwards of $200, so I won't be going that route.
I found an adapter that is female...