Home Theater Forum and Systems banner

compromise

  1. Where Do I Compromise?

    Home Theater System Recommendations
    I’m building a music/HT system (60/40 split) and down to deciding on the processor, subs and amps. Looking at somewhat higher-end and slightly less high-end equipment. If you were to compromise or cut corners in one of these categories in order to save money, which would it be? My last system...
  2. Seeking advice for best audio compromise for multipurpose room

    Home Audio Acoustics
    Hello, Barring a job loss prior to implementation (estimating this January for purchases), I'll be finally setting up a front projector in the basement family room this year. I've been researching off and on for ~6 years, so while I'm anxious to pull the trigger, I'm also patient. The basement...
  3. One compromise sub - small footprint - otherwise no holds barred

    DIY Subwoofers - General Discussion
    I am not as new as my membership would imply, I've just taken a bit of a sabbatical. Anyway - I've been searching this site and others for information on my requirements without a whole lot of luck. I think I get more confused because there always seems to be a factor I hadn’t considered...
  4. Good news, Bad news, Compromise ?

    Chat Box SWAMP
    The Good News Got offered a second job :clapper::clapper: now i can save for the LS6 speakers. The Bad News The State of A-1-3 The compromise Poor man's LS6s :rock::rock::rock: excuse the mess was moving stuff around have a good day ed
  5. Input level - compromise between bits or amp performance?

    Electronic Processing/Equalization Devices
    Forgive me asking (considering it has been covered - in some way - dozens of times before, as far as I can read) but it is about the usual input level settings for the BFD (1124p). I need your help to interpret the best solution: When setting the input level of the BFD one can either calibrate...
Top