Home Theater Forum and Systems banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 121 Results
  1. DIY Speakers
    could i use the crown 1502 to safely drive a single duel 4ohm sub with an rms of 500watts [250 per coil] wired to 2ohms (one on the left an one on the right channel) an feed each 775watts my woofers is the Audiopipe 15" TS-CVR 4-ohm DVC without burning them out i think it would be 137.5watts...
  2. Pro Audio
    Gday guys. im new here and this is my first post.. apologies if its not in the correct place. ive rackmounted alot of amps and pro audio gear in the past always going off the rule of thumb to "stack the heavier items below to support the weight of the rest" especially when there are no rear...
  3. Subwoofer Amps | High Pass Filters
    Hey Shacksters , I am currently running a Crown XLS2502 2 channels at 775 @4 ohms per channel with 2 Ultimax 12" Dayton audio subwoofers in sealed 2.0 cuft enclousures. Is the Behringer I-Nuke NU6000DSP boasting 2 channels @4 ohms 1500 watts RMS and 3000 watt peaks per channel really have...
  4. Home Theater Receivers | Processors | Amps
    Hi everyone, I am looking for an affordable power amp for my towers Paradigm Monitor 11 v.7. The preamp is an AVR Yamaha RX-A870. I listen only stereo, front 2 channels. In my final list I have those amps: Yamaha P2500S (do not have RCA inputs, but I have cables RCA->Jack, and also have high...
  5. Two Channel Audio
    My crown I-tech 4x3500HD amp is installed in a server rack in my living room and its too noisy. The fans on this amp run constantly (this is normal on these amps) and spool up and down as needed (no error with their operation) The amp has two fans, the one that cools the amplifier modules is a...
  6. Home Theater Receivers | Processors | Amps
    I have 3 jbl 3677 for my front LCR going behind my screen. I was curious about the crown dsi-1000 amps. I have read that they have the preset eq curve pre-programed in them for the jbl equipment. I have reviewed the crown web site and don't see any info on this. My question is... Are they...
  7. Classifieds - Wanted
    I'm looking for a Crown amp that has 600wpc @ 4 ohms and around 200-400 watts @ 8 ohms. Prefer it be in the XLS or XTi series listed above, but open to options.
  8. Home Theater Receivers | Processors | Amps
    Has anyone used a xls crown Amp on a pair of 683s. From what i read bowers and Wilkins do pair up with rotel quite nicely. I will be using a xls Amp to power my substage it would be nice to keep the amps in my rack the same . My set up is for Ht and music listening..
  9. Official DVD and Blu-ray Reviews
    http://www.hometheatershack.com/gallery/file.php?n=73625 Title: The Hollow Crown: The War of the Roses Movie: :4stars: Video: :4.5stars: Audio: :4stars: Extras: :2stars: HTS Overall Score:79 http://www.hometheatershack.com/gallery/file.php?n=73633Summary “The Hollow...
  10. Home Theater, Audio and Video News
    Today marked the beginning of CE Week 2016, a multi-day technology and consumer electronics event happening in the heart of New York City. This year’s event features wearable electronics, robotics and drones, 3D printers, connected cars, virtual reality, smart home gear, home theater audio and...
  11. System Setup and Connection
    how do i hook this up to my Yamaha RX-A840BL reciever? i want it to drive my infinity alpha40 towers. I'am new here so thank you for your help.:wave:
  12. Home Theater Receivers | Processors | Amps
    Ok, i bought 2 Crown xls 1500 first gen amps because they are a great deal right now. I have a Yamaha reciever which i know does not supply the proper voltage required by the crown amp to run at full potential. So i ordered a ART Cleanbox Pro. Will go AVR-->RCA-->Cleanbox-->XLR-->Crown XLS. Now...
  13. Pro Audio
    Ok, i bought 2 Crown xls 1500 first gen amps because they are a great deal right now. I have a Yamaha reciever which i know does not supply the proper voltage required by the crown amp to run at full potential. So i ordered a ART Cleanbox Pro. Will go AVR-->RCA-->Cleanbox-->XLR-->Crown XLS. Now...
  14. System Setup and Connection
    Ok, i bought 2 Crown xls 1500 first gen amps because they are a great deal right now. I have a Yamaha reciever which i know does not supply the proper voltage required by the crown amp to run at full potential. So i ordered a ART Cleanbox Pro. Will go AVR-->RCA-->Cleanbox-->XLR-->Crown XLS. Now...
  15. Pro Audio
    I am running a crown Xls2500 and a Minidsp . Is their any advantage to upgrading to the crown xls2502 . What does it mean when crowns says the xls2502 hash more DSP ?
  16. Subwoofer Amps | High Pass Filters
    I have one diy 18" and I'm working on building a second matching one. The one that is completed already has a Dayton spa1000 mounted. I have someone who wants to trade a crown cl4 (1200wx2 In to 4 ohms) for a Fi driver I am trying to sell. I'm just wondering how a pro amp like that would compare...
  17. Home Theater Receivers | Processors | Amps
    Hello, I've read through Wayne's thread on how to properly setup the gain structure when using pro amps and have some questions. I'm using 2 XLS1000's connected to an Emotiva UMC 200 and have an noticeable hiss (easily 3-4 feet) through my 4 surrounds which is what's connected to these amps...
  18. Home Theater Receivers | Processors | Amps
    Hello Folks, With my new Axiom M100s on there way I am thinking about upping the power going to them (currently I have the Denon X4000). I have looked at the Emotiva XPA 200 but after duty, taxes, shipping and exchange rate it hits the $1k Canadian mark. I have been looking at some pro amps...
  19. Subwoofer Amps | High Pass Filters
    A Crown STI is for sale on craigslist for 350. It is 800 watts a channel at 4ohms. I would be using it to power 2 sealed SI18's anyone have any experience with this amp? It is supposedly new in box never used. Sounds like a good deal since they are 679 plus tax on amazon. I have heard pro amps...
  20. Subwoofer Amps | High Pass Filters
    I'm planning the dual FTW-21 subs that I want to build and will have two separate subs that are sealed each housing the FTW-21 sub. I was really interested in the Crown XLi 3500 for it's dual 4ohm capable of 1350w for each channel. Obviously this doesn't have DSP but I will plan on doing a...
1-20 of 121 Results
Top