Home Theater Forum and Systems banner

curve?

  1. REW Forum
    Hi guys Just thought Id throw thoughts out there. I will my tuning some theater rooms in the near future eqing internally within the receivers. These are 9 band channel dependent bell EQs. Im wondering how you guys go about eqing. Do you eq your room for flat then thru the gain stage add another...
  2. REW Forum
    Hi guys, I've just been following the REW forum and began to use REW software with my eD A2-300. I then began my journey in flattening my sub by purchasing an eQ.2. It works relatively well in my room. However, recently I noticed a thread of Wayne about house curve and it changes everything...
  3. REW Forum
    How do I create and save a Hard-Knee target curve? Hope I don't sound too dense here:hide:.I understand the concept of how you want to find the difference at say 80hz and 30hz and use that number for your slope,but for the life of me I can't find out what you do with this number?Lets say for...
  4. Electronic Processing/Equalization Devices
    Hello again, Set up my BFD today and would like some input. Here is what I started with: Front subs: Rear sub: Through moderate low boosting (I know it's usually not recommended, but the concensus seems to be that it's okay if it actually helps), I was able to get it truly flat: Front...
  5. Electronic Processing/Equalization Devices
    Noob here, but I've used REW to determine Audyssey has given me a fairly flat response. I've been reading the guides on hard knee house curves and would really like to give it a try. Before I pull the trigger on the BFD 1124P I was hoping to get some input. Seems the consensus is to use the...
  6. SPL Meters | Mic's | Calibration | Sound Cards
    Hi Guys, I ordered an EMC8000 from Musician's Friend only to be told after the order was placed it is out of stock until Sept 30th. I want to do some calibrating this weekend, but can find no EMC8000 locally. I can however, find a RTA-M by DBX, but have no calibration data for it. Does anyone...
Top