Search Results for ‘diagram’

iv got a question an i hope you can help im planin to build some bookshelf speakers that have 2 8in woofers an a planar tweeter in a two way config using the Dayton Audio 700-LPF-8 Low Pass an Dayton Audio 700-HPF-8 High Pass but my problem is i cant see how to do that , i know it should be...

Hi Guys, I'm loving the REW tool. I saw this stacked filtered ECT diagram on page 9 of Acoustic Frontiers "Acoustical MeasurementStandardsforStereoListeningRooms. How were the 500Hz, 1000Hz, 2000Hz, and 4000Hz traces displayed like this?

Hi! I just bought a HS 500 from a guy, and it came in 2 pieces, the plate amp and the control panel. It is pretty straightforward, looks like everything plugs together . Problem is, I cant find anywhere to connect the actual subwoofer to. Nothing identified on the PC board as being + or -, in...

I have seen several wire diagrams on the internet but I can't seem to find one to fit my specific needs. The goal is to design and build my own speaker cabinets (DIY) from sites such as: http://www.zalytron.com/ http://www.parts-express.com/ https://www.madisoundspeakerstore.com/welcome.php...

Hi to all. I have taken measurement with REW and Umik-1 of the Audyssey Multi Xt on my Denon 4311, with my hall with 13+2 speakers. In case of use of a minisdp box, i must take measurement and equalization with Umik-1 before of calibration Multi Xt Audyssey or after it? Many thanks to all for...

Hi folks, I have come to use the REW and I am amazed at what performance it offers at such an ease of use! :clap: There is just one tiny detail that i can't figure out: Is it possible, to scale the time axis in the waterfall diagram in periods instead of milliseconds? If not it would be really...

Is there a way to wire 4 X 4 Ohm SVC Drivers and com out with a final Load 4 Ohms? This is not an option on the wiring diagrams. Could you wire some in parallel and some in series to come out with 4 Ohms? 4 x 4 Ohm SVC Drivers / Final Load 1 Ohm

I am new to the complex part of home theater and audio/video distribution. Up to this point, I have only had one room to worry about, and therefore, everything was straightforward. Now I am in the process of figuring out how to distribute audio and video through out the house and I am getting...

Call me cheep (or just flat broke) But i would like to make my own DVI to Component addapter... But I am not sure what wires to use. Does any one know how to do this??

I'm battling to find a circuit diagram for my Av board BN41-00630b. Can anyone help with this?