Home Theater Forum and Systems banner
distances

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. REW Forum
    I have an Onkyo 5507 and running REW (using a loopback) with an ECM8000, mic amp and a SoundBlaster Live 24 bit USB soundcard. When I run a measurement with the Onkyo in direct mode, I get: Delay 8.81±0.01 ms (3.023 m, 9.92 ft) relative to Loopback but when I run it in stereo mode, I get...
  2. Home Theater Projectors
    Hi all, I'm planning a home theatre, and am limited to viewing distance of about 10 ft, and i can have a throw distance up to 12ft about. I was interested in the Benq W1070, but calculators tell me that to have a recommended viewing distance of a minimum of 10ft, throw distance is 10'9''. this...
  3. DIY Subwoofers - General Discussion
    How would 3 subs, all at different distances be level matched and Time aligned at MLP I have 2 identical, that are L+R and same distance , but what if all are at diff positions ??
  4. DIY Subwoofers - General Discussion
    Hi there, I ran Audyessy on my diy dual 18" sealed sub today and it came up with a really short distance of 0.3 metres. Can anyone explain why this is and what I can do to fix it if it is wrong. One thing I did notice was that when the cal came around to the sub the radiator rattled. Would...
  5. REW Forum
    How do I go about getting all my distances aligned, particularly between the sub and the mains? I don't have a phase control to play with, so it's all distances. Thanks.
  6. Remotes | Cables | Accessories | Tweaks
    I have 5 long IR runs from my emitter to the component. The runs are anywhere from 20' up to 50'. Can the IR signal travel that far to an emitter? I ran cat 5e and 3.5mm cables prior to drywall. Any advice would be appreciated...
1-6 of 6 Results
Top