Home Theater Forum and Systems banner

edges

  1. Which kind of screens to avoid curling edges over time?

    Home Theater System Recommendations
    I'm hesitating between buying a pull up / floor screen (such as this) and a regular, pull-down screen (such as that, that, or that). People complain about curling edges with floor screens, is it also an issue with pull-down ones? Does it make a difference if the screen is manual or electric in...
  2. Missing edges of video!

    HDTV | Video Displays | Processors
    I have noticed that some programming has information on the bottom, top, or sides of my screen that I am missing! Is my aspect ratio wrong or is it the broadcast signal? My Pany TC P50G20 is set to the widest possible aspect ratio and image as far as I can tell: "Full/Size2" but I am still...
  3. How do you trim veneer edges on chamfered cabinets?

    DIY Subwoofers - General Discussion
    I am in the process of building three subwoofers (a RSS390HO-4, RSS315HF and a rebuild of a dead Polk PSW650). I am thinking of applying maple veneer on at least one box, but I am chamfering the edges of the boxes. How do you trim the veneer on the 45 degree cuts on the edges? I normally use...
  4. Three edges are square and one isn't? How is this possible?

    Home Theater Projectors
    My PJ screen is 110 inches and I have an Epson 6100 HD PJ with an Onkyo 705 and a PS3. I'm on my 2nd PJ (the other was replaces under warranty) but with the 1st one being taken down when the bulb burnt out (they sent me a new one) and switching PJ back and forth, somehow I can get the top and...
  5. Already built the enclosures- now I want roundover edges?

    DIY Subwoofers - General Discussion
    I've already cut all of the pieces for my enclosures. I've also already assembled both of them, aside from the enclosure tops. I realize it would have been much easier to do before assemly, but now I have decided I want roudover edges. Is there a good way to go about this? If so- how? I don't...
Top