Search Results for ‘generate’

Hi there I'm new to this forum.. ...and let me start by saying rew is some jawdropping technology. Much respect. One thing that is not immediately clear from flicking through the pdf is whether or not the software automatically considers the phase for you before it generates the eq settings. It...

My tests of the generate minimum phase(MP) button is giving some strange results The input and output device used is a bit-perfect miniStreamer with an SPDIF cable looping the input and output. It provides as expected a perfectly flat frequency response with zero phase. I performed 5 sweeps...

I can generate a signal by using Java as a driver with REW. But when I switch to ASIO I can't select a sample rate and REW doesn't seem to generate a signal. Also should there be a 12db gain on the UMIK-1? I'm unfortunately still in the stone age with my AVR so the computer is using a realtek...

I have measured my Left & Right speakers separately. I now want REW to suggest settings for a generic EQ so that the left speaker matches the right. But I can't see how to do that and the help file doesn't explain it. For a start I can only see one measurement at a time - if I could see both...

Hello, until now, I have measured my 2.1 Setup as a whole and then generated a corrected .wav to put into Foobar's convolver (e.g. "yet another convolver"). Now I'd like to to this for right and left channels separately. But how do I realize this, after having measured both channels on its own...

Hi, I'm stuck. As the title suggest i would like to use REW to make a few measurements of my room and make a few corrections. These corrections should then end up as a FIR that I can use with a convolver like jconvolver. I'm pretty much stuck at the last part - getting the nice filter out of...

Just wondering if anyone has come up with a good way to send the calibration signal to non main L/R speakers? The most obvious example I could think of is to generate Dolby Digital (with per channel enable) and output via S/PDIF. Maybe there is a device driver I could use to accomplish this...

I was considering using some sort of "clicker" (or maybe a cap gun?) probably akin to what is used in dog training to generate an impulse from the point in space where my speakers are; this way I could in effect measure JUST the room response (recording the impulse and the reverberation...

Has anyone seen an issue where waterfalls cannot be generated? I took some measurements today (REW 4.11, JRE 1.6.0_13) and I cannot generate any waterfalls for them. When I go to the waterfall tab, I see the measurement file I had opened right above the “overlay” with the check next to it...

Yes I know this appears in a million places, but not in a specific discussion on the following and in a short thread that contains several but specific opinions without wandering... I have a very near zero to zero ambient light home theater. I have a gallon can of Behr "Ultra" Exterior Flat...

Hello, I've seen numerous times people posting waterfall charts(?), as seen here for example. I guess the purpose of these is to analyze part of a source signal (like the ripped audio from a DVD) to show what frequencies are truely present in the recording (thus, for instance showing in theory...

I'm trying to come up with better and more repeatable process of generating filters for my Meridian processor. For more info read this http://www.meridian-audio.com/w_paper/Room_Correction_scr.pdf Meridian believes in attacking just slow decaying frequencies. I'd like to take all my...