Home Theater Forum and Systems banner
ic's
1-6 of 6 Results
  1. Philips / Magnavox
    I replaced the IC's in my 60pp9202/17f. I turned on the TV only to find It did not fix the problem with the Blue being pulled in at all four sides and not being able to adjust the convergence up or down for the Blue. Side to side is ok. So I did more research and found this site. I found...
  2. Mitsubishi
    Hello all, I have replaced convergence IC's previously on my Sony rear projection TV with no problem; however, I recently replaced the convergence IC's on my parents Mitsubishi VS-60607 rear projection TV with no improvement in the convergence. Attached are links to a few pictures illustrating...
  3. JVC
    I replaced the IC's on my JVC AV-56WP74. After reading the posts I replaced the STK 110's with STK 394-160's. The color guns worked before the replacement but now after the replacement they do not. They convergence board is getting power (the IC's are heating up). You can hear the click like it...
  4. HDTV | Video Displays | Processors
    Lately there seems to be allot of people with problems on CTR RPTV's with the convergence IC chips going bad. It seems to be very brand specific as well as I rarely see Sony displays with this issue. My RPTV is over 7 years old now and still have never had any issues with it. Is there something...
  5. Hitachi
    So as a project, I purchased a used 43UWX10B off of craigslist. I purchased it knowing that it had convergence issues. I ordered the X480293 kit (Sanyo), and replaced the IC's and the resistors. It looks like the repair had already been attempted because of the of the resistors in question had...
  6. Mitsubishi
    Mitsubishi HD1080 55" Rear Projection TV, Model WS55809, exhibited convergence problems, whereby Red, Green & Blue CRT's lost alignment with corresponding images and concaved picture appeared on screen. Digested earlier streams posted by Icallio, which matched condition, purchased two new...
1-6 of 6 Results
Top