Home Theater Forum and Systems banner


  1. Interested in a very authoritative sound?

    Audio Processing
    If so then these speakers are your best choice :) Ciao, Flavio
  2. Interested in SDX12

    Creative Sound Solutions
    Anyone know if the SDX12 would be a good match for Paradigm Monitor 7's? Recommend stuffing for sealed boxes? I'm super interested in these drivers... hesitant to place an order though. I've tried emailing CSS three different ways and no responses :foottap: Not sure if they are still in...
  3. newbie interested in making some acoustic improvements

    New Member Introductions
    Hi everyone I came by HTS when I was googling acoustic improvements in home theaters. I found REW, thus also found this forum. Cheers from Belgium :R
  4. New member interested in REW and larger room treatment.

    New Member Introductions
    Like the title says I'm interested in using REW for larger 60 x 50 feet (with 12 foot ceilings) spaces. Any pointers to groups or posts that deal with sound reinforcement (PA speech mostly) for 100 to 200 seat auditoriums would be appreciated. Shaun
  5. Interested in Improving my theater set-up

    System Setup and Connection
    Hello HTS, It has been a while since I have been active here. But after moving from my last apartment, I have a larger room for my system. But more recently after attempting to reduce the volume of my movies at later times at night. I have been currently going from THX Cinema + Sub during...
  6. Looking for "friends" interested to DIY-make a state of the art DXO-DRC using a COTS device like the MOTU 896 mk3

    Audio Processing
    Dear All, I have a dream, make myself a state-of-the-art Full Digital Preamplifier with an Advanced Digital Crossover and Digital Room Correction embedded. My dream is to make something better than the DEQX-HPD-3 and, for some cases, even better than most famous TacT. And doing all with a...
  7. My name is TheDie and I am interested in acoustic room simulators

    New Member Introductions
    Hi everyone, my name is TheDie and I found this forum on my search for room acoustic software. I plan to digg deeper in the domain of room acoustics. Therefore I am looking for software that can adapt sounds to different rooms sizes or change sounds according to special surfaces of virtual...
  8. Is anybody here interested in Solar or Wind Power ?

    Chat Box SWAMP
    Is anybody here interested in Solar or Wind Power ? I have a 100 watt solar power system that charges a truck battery. Then I use the straight 12 volt power to operate a bunch of stuff around my computer desk like: Fans, Lights, Cable Modem, Router, HDTV Converter, Computer Speakers, Charge...
  9. Poll: Are you interested in buying Google TV hardware?

    The launch of Android in the living room is closing in on us, and with the Chrome to Phone push app going official plus a quick mention by partner Dish Network on its earnings call we're wondering what you're thinking of Google's technology so far. As a mobile platform Android is doing well...
  10. For anyone interested - 10 dollars off Alice in Wonderland BD Combo

    Movies | TV Shows | Hollywood
  11. Interested in a BFD .. dual mono subs ... where do I start?

    Electronic Processing/Equalization Devices
    I tried to read the FAQ: http://www.hometheatershack.com/forums/bfdguide/ But the bottom of page two ("Manual Measurement Method") links to itself, not the next section. I saw no "table of contents" on the first FAQ page to jump past it ... In short, I have dual 10" sealed subs, each with...
  12. noobie interested in shiva-x2

    DIY Subwoofers - General Discussion
    hey guys I'm interested in building my first sub to complement my zaph audio sr71 bookshelf mains. I'm going to be listening to rock/metal 50% of the time using 2.1 and will use the sub the other 50% in 5.1 for ht/xbox. The sub will mostly be in a room that is 12'x16' and occasionally in a...
  13. Interested in 12v triggered delay on/off outlets?

    AV Home Theater
    I hope this is not against the rules - if it is, please move or delete this post. I would like to know if there would be any interest in a product that was a power switcher. It seems like to get this capability would either cost more than $300-400, or I need to use a power conditioner that has...
  14. TRADE: Want to trade my Behringer EP1500 for an O Audio 500 watt Plate amp.

    Classifieds - Audio Equipment
    I have a Behringer EP1500 amp that I am willing to trade for an O audio 500 plate amp. The EP1500 is in like new condition with no scratches or dents of any kind, you will really think its brand new. I have all the manuals and the original boxes it came in. I will even throw in 2 Dayton RCA to...
  15. I am interested in a DIY subwoofer.

    DIY Subwoofers - General Discussion
    I am interested in buildign my own subwoofer or perhaps talking too someone about helping me build one. because of my vision i'm not very handy with power tools and such. mind you i'm not ignorant of them either. i would like some suggestions as to a design that would be fairly easy to build...
  16. Anyone interested in a 22" IB3?

    DIY Subwoofers - General Discussion
    We just received our first proto of the 22" 12 spoke basket and Im rather happy with it :) Got me thinking that the IB crowd might be interested in a 22" version. Currently the surround and rubber gasket are being tooled and I should have a surround sample in about 2 weeks. But... cone bodies...
  17. Found these feet in case anyone is interested.

    DIY Speakers
    Hey guys, I'm a DIYer and I know some of you may be interested in this. So this is no spamming but sharing the wealth here. I found these feet on Ebay. These are like those that were on PE at one time, guy says he has some to sell and he seems standup with good feedback. Check out the...
  18. Anyone interested in high tuned TC-3k project?

    DIY Subwoofers - General Discussion
    Hey guys, Sorry about the delay on the subjective sound quality measurements I promised a while ago. The measurements will likely take place some time in June-July for those still interested. In other news I've been interested in experiencing what a TC-3k is capable of in a ported alignment...