Search Results for ‘interpretation’

Here are my measurements of my two subs at the MLP. How does my room look? What should I do at this point? Any advice would be greatly appreciated. Thank you.

So I received a miniDSP UMIK-1 for Christmas and wanted to take some measurements in my home theater room. I read through the long manual for REW and I have to admit that about 95% went way over my head. No big deal, I figure I start easy and basic. I should probably explain my setup. It's a...

Hi all, I'm new to all this, so please bear with me. (Have attached 2 x REW settings files for your reference.) I got a Mac with REW, Behringer ECM8000 and an Apogee One audio interface. I have done a measurement at my home studio and I did one for a restaurant where I recently did a sound...

Thanks in advance to the folks who helped my out a few months ago. Wayne +1. I moved and I'm back to testing one of the rooms in which I hope to record classical guitar. It has a cathedral ceiling, sliding glass doors and plate glass windows and a rug. Understood it's not ideal, but it's where...

Here is the first measurements I have made with my DSP. I ran two flat sweeps with no EQ. Then ran the EQ utility in REW and ran again. I'm seeing very little change. Thinking I could possibly be doing something wrong. I am running the sweep with the Main towers operation with a Xover at 100Hz...

Hi all, Firstly thank you to the creators and moderators of this forum. I downloaded Room EQ Wizard and ran a test of my (imperfect) room with a Behringer ECM8000. So far I found information regarding performing the test, but not much about interpreting the graphs. Can anyone point me in the...

Wrong place Sorry

Hello, I need some expert opinions and suggestions on the bass response of my 2 channel system. Here is a screenshot and data file of my most recent REW measurments. This was running the Mains + one sub. Below is the best (flattest) curve I could obtain after hours of adjusting phase...

Hi, Can somebody explain me what rectangular lime area, t<0, represents , please? Thank you, crom

Hi, Here are my latest measurements after I placed the subwoofer in the best available position. There are 3 sets of measurements, 80Hz crossover. -mains and sub -mains and sub with Audissey -sub only I'm looking for your interpretation, opinions and advice. Thank you very much, crom

Hi everyone, I have a 2-channel system setup in my living room, and I'm trying to setup the room the best way that I can to get the best sound possible. I downloaded REW and I'm using it with a calibrated Galaxy CM-140 SPL meter feeding into my laptop. Just some quick info on my room, which is...

Hi, I just now ran some REW tests on my home theater. Here are few graphs. I am not sure what to look ofr? Does this look normal, does anyone see an area I should focus to fix? Thanks

Hi, Yesterday I finally got some time to measure around my PB13. The most important reason was I wanted to check if the SVS was positioned well against the wall. (since I'm about to construct a piece of furniture that would make the current position of the sub rather permanent...) Basically...

So who knows what waterfall charts are telling me? I haven't got a clue what I'm supposed to understand from a waterfall. Below is a response of my main system. It has always had a nice sharp dip at about 27Hz - I've never been able to hear it. I suspect it's too narrow to create much of a...