Home Theater Forum and Systems banner
levels?
1-4 of 4 Results
  1. Electronic Processing/Equalization Devices
    I'm curious how you guys using the BFD with Audyssey set the sub trim (input level) for the BFD? My plan is to get a flat response with the BFD first. I'll set the sub trim per the BFD guide. However, when I then run Audyssey, it will change the sub trim, which changes the input level to the...
  2. REW Forum
    In the expert articles I've read from here, a step in determining your house curve mentions to adjust the levels of two reference frequencies so they're purceived to have equal output. My question is how am I adjusting these levels? Is this from the receiver trim levels for the sub output, the...
  3. REW Forum
    When using REW to compare say:left channel to right channel etc...how accurately does REW match the the measurements to the target level of 75dB and to each other?Are they just matched to a 1Khz centered band limited pink noise level the way the processor/reciever internal tones are used to get...
  4. Home Audio Acoustics
    I finally got a decent set of speakers to replace some hand-me-down Bose cubes (I know... but they were free). The new speakers (Jamo C807s) put out a lot more sound pressure however, and while dialog and lower volume effects sound MUCH tighter, once the SPL ramps up things are starting to get...
1-4 of 4 Results
Top