Home Theater Forum and Systems banner

light

  1. Mitsubishi
    I just replaced the convergence IC for the second time and the 7 capacitors for the first time on this unit a couple of months ago. About 3 weeks ago (been too busy to post on this), I turned on the TV in the morning and withing about 5 minutes it shut itself off and the power light began...
  2. DIY Screens
    So my father really wants to get into world of projectors and so I am tasked with picking out a projector/screen combo and setting up the room for him. I currently have my own setup which i really like, except I used Rsmaxxmudd in my particular setup and found it to be expensive and a pain in...
  3. New Member Introductions
    hello I have a p50h401,and theres no picture just the blue solid power light on.any ideaS what can be the problem?
  4. Remotes | Cables | Accessories | Tweaks
    I need a light I can put in one of my recliner cupholders to help me navigate my remotes when the room is dark. Thinking of a gooseneck with small halogen or LED on the end, with an opposite end that would insert into the cupholder. I have seen them in theater seating accessories, but the...
  5. General Screen Discussion
    I know the general consensus is that ambient light viewing should utilize a grey screen to help darken the blacks, but with a higher contrast projector (such as the Panny AE-7000u) could decent blacks be achieved in an semi-ambient light condition?
  6. Mitsubishi
    https://plus.google.com/photos/104493257387768811297/albums/5774363187795605345/5774363188052812050 Hi, Wondering if anyone has had similar problems with the color on a 60-738? It seems like there is no blues... only shades of red and green.... would it be a bad light engine or color wheel??
  7. Samsung
    Hi all I have been stumped on what is wrong with my samsung and would be grateful if anybody knew what could possibly be the problem About 4 months ago the bulb went out and I replaced that on my own Around that time the set started making a loud grinding noise (later found out to be color...
  8. Hitachi
    Please, anyone help. I was watching my TV when all of a sudden the screen went blank. I checked my input signal, fine. I cycle power at the main switch and the light flashes 8 times. I purchased the service manual and pulled off the back cover to see the LED on the Digital Main Board and after...
  9. Samsung
    haven't been on for a while. But I just picked up a samsung hl-t5075s, the old owner said capacitors. Well, they said it would go off and come back on, over and over. I don't know what to think but it is a 3d ready as well so I grabbed it up. Now I took off the back, turned it on, and only...
  10. General Screen Discussion
    Hello all! Just a quick question - I am not able to put my speakers behind and AT screen due to the size of my room. I had always thought I should do a black speaker so that I do not have to worry about light refracting off the speaker and potentially losing video contrast. Is this a...
  11. Home Theater Design and Construction
    Ok this isnt for a HT but I'm a moderate Shackster and REW user and my boss asked me to help him soundproof his (half-built) conference room. I figured I could maybe get some advise here at HTS :) He's building a new office from the ground up basically. He started building the conference room...
  12. Home Theater Projectors
    My Screen Shots of Epson 8350 with Lights On Well now that I have my first projector and after countless hours of reading online to find the right one and from the help of you guys on the forums, its time i start lending a helping hand as well. My biggest concern for a projector was how it...
  13. DIY Repair and Maintenance
    Hi all This is my very first Thread First of all i wish all the best for all the guys who are experienced and take their time to help peoples like me with a great Hope of repair and make dead electronics alive...Thank You so so much I came here with a great Hopes after searching tremendous...
  14. Home Theater Design and Construction
    Has anything new came out in the way of IR Dimmers and switches lately. Last I checked it was Grafikeye - Too expensive, or Maestro - not enough control for what I want. I have a 4 gang box with 3 dimmers and one switch. Want to control each indipendently and have a few presets that would bring...
  15. New Member Introductions
    Hi all. Nothing much to say for now 'cept, ".... hi all" ;) Lots to read here, so I better get on with it. Cheers to all... :)
  16. General Screen Discussion
    Hi, My HT room is shared with my lounge. So I am stuck with a white ceiling and light-medium coloured walls. I only watch movies at night time, yet even with all the lights off, the walls tend to reflect the light from the screen resulting in tons of ambient brightness in the room. This means...
  17. Hitachi
    I was wondering if anyone could help with my broke Tv The problem with the tv is when u turn it on you get the red standby light and when you press the power on button on the remote, the light turns blue then flash`s 4 times I can not afford a new tv at the moment and was hoping it could be...
  18. Home Theater Design and Construction
    I've had a ceiling light tray in my theatre since it was built..It's looking a bit worse for wear of late with some warp-age and swelling of the plasterboard panel.. I have an almost flat roof of "Cliplock" with very little space between roof and ceiling and certainly not enough room for anyone...
  19. General Service and Technical Information
    Okay so my problem isn't the flashing light problem that some people get. The issue is I switched off the breaker to my ht room outlets and when I turned it back on the standby light on my 6003 isn't lit. It powers on fine and functions but there's no light on when you turn it off. Do you think...
  20. Hitachi
    Hi all, I have been reading through the posts and have found my Plasma TV having similar problems, though the TV seems to work sometimes. Sometimes it goes into the 3 times blue led blinking mode. I unplug, wait for a 2 or 3 minutes and then plug back in and the TV starts working again for the...
Top