I am not sure how to set up the channels for the measurement. People recommend taking measurements for SUB with L and R together. How do i set it exactly? , in the output I select HDMI 4 (LFE) and in the timing reference output should i change to Left and Right? .
And in the REW spl meter...
Why does the SPL drop when I measure my mains with the sub versus just the sub? Below is a graph showing this effect:
Same mic location (MLP), same settings in the AVR, same volume, same everything. What gives?
Hopefully I'm posting this one in a suitable place - tried searching this one on the web and several forums - spent a lot of time - and did not get my answer, so here it goes:
Just got my AVIA II DVD and started running through the various tests, and when I got to the phase tests, the front...
I have been trying to set up a new system. It appears that the right channel of the audio from my Comcast AVR is higher than the left. When I play a DVD the system appears balanced. I have compared the outputs using headphones. I can compare the analog outputs with an oscilloscope.
How can one...
wondered if you had any comments on the 8K to 10k plot dynamics..
I measured left, right and then both as you can see.
do you think this would be destructive interference from boundary early reflections, phase issue?
Adam p11a, studio control room, rta-m mic, room cal in place, mic...
Living Room 2-ch system:
Simaudio W5 x2 (with Audio Control Richter Scale III serving as active x-over)
Simaudio PSP phono preamp (to be tweaked)
Simaudio Moon Nova cd player (tweaked)
Fanfare FT-1A tuner
Phase Linear PL-8000A turntable with Grado platinum cartridge