Home Theater Forum and Systems banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 14 Results
  1. Audio Processing
    Hello HTS! It's been a while, since i posted a thread on these forums, feel free to move it, if i got the place wrong. I recently upgraded my system with a used Denon 4311 - to get MultiXT32. I absolutely love it - everything sounds like heaven, and the 140w pr. ch (170w in 2ch) does a good...
  2. SPL Meters | Mic's | Calibration | Sound Cards
    I am taking measurements with REW but have a small problem. As soon as I plug in an RCA to 3.5mm jack cable into the output connecter the guage reads maximum. My PC still manages to get proper readings so I am curious as to why this is happening. Thanks in advance.
  3. Florida
    Over 85,000 customers and over 30 years since our beginning in 1982. Maximum Home Theater specializes in complete audio visual systems, media rooms, home automation, and smart house wiring. We are passionate about designing a system that will compliment your home with “tomorrow’s” technology and...
  4. Ported Subwoofer Build Projects
    I'm somewhat new to ported subs, but I understand the basics. However, what is the absolute maximum port air velocity that can be used without tons of port noise? I am designing two subs, one extends much lower than the other but has much higher port velocity (65m/s). The other doesn't extend as...
  5. SPL Meters | Mic's | Calibration | Sound Cards
    I'm trying to ascertain what SPL levels will damage the little 6mm capsules that are used in the various measurement mics. It seems most of these are rated to around 120dB. But I can't find any information on a damage limit. Presumably there is a point when the diaphragm is physically damaged...
  6. Electronic Processing/Equalization Devices
    According to what I have read, when setting up the BFD it should be at the -10db input and set up so that at the maximum listening volume, the output level of the sub from the AVR should be set so that the maximum deepest bass causes the BFD red light to come on for no more than a flicker here...
  7. DIY Subwoofers - General Discussion
    I am Building two sono subs with 15's, 24 inch diameter 6 feet high, or about 18 cubes apiece tuned to about 17hz and feeding it with a ep2500, my question is what port size is too big.:dontknow: I got a piece of 8 inch tube but not sure if it's too large, speaker parameters Re: 3.95 ohm Qts...
  8. Remotes | Cables | Accessories | Tweaks
    I am curious as to the maximum length of a HDMI ver. 1.3 cable that can still carry full 1080P along with all high def audio when that audio becomes available? Mike
1-8 of 14 Results