Home Theater Forum and Systems banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 319 Results
  1. DIY Repair and Maintenance
    tv powers up, steady green light, "power loss please reset clock" appears on screen but is bowed down in center. Error code 12 indicating no error. I can change inputs but no video or audio. tv had convergence repaired by previous owner but don't know how long ago. Was givin this tv 3mos ago...
  2. DIY Repair and Maintenance
    Right now, my TV is flashing green light after a convergence repair. I have just replaced the DM caps and I still have the same problem. I'm hoping to find some help to keep my Mitsubishi WS-65869 going for another year or more until OLED's mature a bit! The initial problem was that the TV...
  3. DIY Repair and Maintenance
    Hi, my name is Steven and I stumbled across a thread regarding a Mitsubishi ws 55313 that won't power on. I haven't seen my exact issue, so I'm making a new post. Sorry if I overlooked an existing one with my exact issue. The TV had error code 22, and I have already replaced the convergence ic...
  4. General Service and Technical Information
    The volume is so low that you can barely hear it. The volume is all the way up. Is there something in the set up I am not getting?
  5. Blu-ray | DVD | Disc Media Players
    I'm not exactly sure where this should be posted, but since two Sony Blu Ray players (BDP-S580 & BDP-S5200) are doing the same thing and nothing else in my setup is (Amazon FireTV & uVerse reciever), I can only assume it's something with the Sony Blu-Ray players.... I have a Mitsubishi WD-52627...
  6. Mitsubishi
    Replaced 2 convergence chip and one pico fuse and it blew again the pico fuse tv wont stay on, should we replace resisters or don't know day 4 into athis, also it had a blinking light error code 2-2 so that is why we changed out the convergence and only one pico fuse was blown, now installed...
  7. DIY Repair and Maintenance
    I have a Mitsubishi Model# VS-50703 that went out last night. I left the room while it was on and when I came back it was off. I pressed the power button on the remote and heard a screeching sound come from the TV then there was a burning smell. I turned the TV off...waited for about 5 minutes...
  8. Mitsubishi
    I've not yet found info anywhere describing the problem that I'm having. I've seen issues that are close tho. While TV is not powered on - I'll just be reading quietly. Out of nowhere I'll here a click and notice the green light flashing, then it stops. Very similar to when I power the TV...
  9. Mitsubishi
    Hi all, I have a 10-11 year old VS-A50 and I went to turn it on the other day and the green power light comes on for 2 seconds and then it shuts down. I pulled the diagnostic code and it is 2-2. What does this indicate and is this something a real novice can deal with or is the tv done? Thanks...
  10. Home Theater, Audio and Video News
    Nearly one year ago Mitsubishi Electric rocked the electronics world when it finally pulled the plug on its rear-projection television division. It was the last holdout of an aging technology that once was the battle ground of a variety of micro-display technologies including DLP, LCD, and...
  11. System Setup and Connection
    I have a Yamaha RX-V673 av receiver, a direct tv receiver and a mitsubishi HC3000 projector, connected via HDMI. Everything was working fine until the other day when I began to get sound but no picture. The screen read "no signal." I connected the component video cables from the direct tv...
  12. Mitsubishi
    Yesterday morning, my husband turned on the TV (using the Tivo peanut remote), proceeded to pick something from the Tivo queue, then something happened. I heard a muffled thump inside the TV, then the screen/TV shut off completely. We unplugged the TV for several minutes ("did you remember to...
  13. Mitsubishi
    Hi everyone I think my tv is dying possibly. It's a dlp tv and we suddenly have a small white dot flashing on the screen getting worse all the time seems to be in the middle of the screen any ideas. Thanks in advance.
  14. Mitsubishi
    My 65813, which was the best set on the market in late 2003, is beginning to show signs of dying. And I was hoping it might last a little longer but I think it's going to be dead in a matter of weeks, if not days. The problem is that when the set initially comes on, one of the guns is horribly...
  15. Mitsubishi
    I have a Mitsubishi ws65909 that had the green blinking light problem. I removed the DM board and replaced the capacitors. TV worked good for about a year. Then the green blinking light problem came back. I pulled the DM board out again and the caps look good. But, 2 of the caps are loose on the...
  16. Mitsubishi
    I just replaced two convergence IC chips (stk392-570) in my mitsu ws-65809 65 inch, I also replaced 20 and 22 pico fuses (the two fuse's for the IC's), the set was completely dead prior to repair, no error codes and no blinking green light, I replaced the IC chips and the two pico fuses and now...
  17. Mitsubishi
    I have a Mitsubishi WS 55413 and am trying to remove the PCB on the right. I have it all unhooked except for the white wire attached to the flyback transformer. It has a rubber collar around where the wire comes into the Flyback and it doesn't pop off with a firm pull. I don't want to just yank...
  18. DIY Repair and Maintenance
    So here's one for somebody with some tech expertise....Mitsubishi WS 55315 that is several years old, but has really low mileage on it because it is in our basement and the system we use the most is on the main level in our home. It started acting a little flakey several months ago and I've...
  19. Mitsubishi
    Hi, First, thanks for this forum, I've learned a lot already. I just replaced the two convergence chips in my WS55819 after it developed a "3d effect". I had to call in a professional after the problem returned, and he said that I just didn't use enough solder in a couple of spots. After...
1-19 of 319 Results
Top