Home Theater Forum and Systems banner
n00b
1-14 of 14 Results
  1. REW Forum
    I purchased a UCA222 and was running REW using my RadioShack Digital SPL Meter and inputted the data into my Emotica UMC-200, but the sound is very muddy. I suppose this makes sense since it only good up to 3Khz. So I decided to purchase the Behringer ECM8000, but now it appears that I need to...
  2. REW Forum
    1) When posting a graph is there a preferred smoothing value? I've seen graphs ranging from no smoothing at all to 1/3 octave. 2) It looks as if I need to measure the left and right mains separately. That makes more sense than my first attempt using both mains. I'm planning the following tests...
  3. New Member Introductions
    Joined this site as it came recommended to me by a fellow friend of mine, to help me fix my plasma tv.... Thanks guys
  4. Home Audio Subwoofers
    My current specs: AVR: Denon 1712 Front: Pioneer SP-BS41-LR Center: Pioneer SP-C21 Rear: Pioneer SP-BS21-LR Requirements: $300 +/- 75% use for HT, 15% music, 10% games. Listening room is 10' x 10'. Maximum Height (excluding support legs, etc) needs to be 18" -OR- Maximum Depth needs to...
  5. Home Audio Subwoofers
    the manual says it is 19.2" but does that measurement include the bottom support legs/pegs? I have an 18" opening subwoofer cabinet and I want to know how tall is the Klipsch rw-12d without the support legs becasue I intend to remvoe them? if you have or had this subwoofer can you tell me? do...
  6. SPL Meters | Mic's | Calibration | Sound Cards
    Hello, I am new to this calibration game, though I've been wanting to do it for years, I never got around to doing my research. I'm now ready to jump in whole heartedly into it and need to clarify a few things. Mic I will purchase a calibrated mic from Cross-Spectrum. Question is, once...
  7. REW Forum
    Hello, I have a non symmetrical cnotrol / recording room (see Plan). I want to know if there's any point in treating the room before I buy nice equipment to put in, or I can use some fancy EQ trick to do the job. So first things first: understand the room. I read that it might be best to...
  8. Home Theater System Recommendations
    Howdy, folks, I'm planning to build a dedicated listening room in my new house. I'll be building this system from the ground up with a modest budget. I started off aiming to keep it under a grand, which quickly ballooned to $1500, but has since been shaved back a bit thanks to some awesome...
  9. Ported Subwoofer Build Projects
    After months of reading, researching, learning to use WinISD, etc etc, I finally built my first ever subwoofer (and first ever real "woodworking" project)! The basics break down like so: Dayton RSS390HF 15" driver - purchased from a fellow forum member BASH 300w plate amp from PE Box is...
  10. REW Forum
    This is my system: Primary Source: Toshiba DVD SD-2700 Receiver: Sony STR-DE675 Samson S-Convert EQ: DSP-1124P Amp: Behringer EP2500 Subs: 2 Ascendant Audio Avalanche 15" 3.5Ft^3 @28Hz each (1 to each channel at 4 ohms, one on each side of the TV) Here is my sound card cal. Soundcard Behringer...
  11. REW Forum
    Hi All, I have been into audio for a long time, but just starting to learn about room acoustics and specifically how to measure responses. I am trying to set up a home studio mixing room (on the cheap). I did a measurement of the room using the Radio Shack SPL with calibration files, along...
  12. REW Forum
    Hi All, I have been into audio for a long time, but just starting to learn about room acoustics and specifically how to measure responses. I am trying to set up a home studio mixing room (on the cheap). I did a measurement of the room using the Radio Shack SPL with calibration files, along...
  13. New Member Introductions
    Greeting from NW PA! I am over at AVS forums and am about to start yet ANOTHER project in DIY's .I finished off my basement about a year ago and have the DIY bug again! About 10 years ago I built a home sub with an Adire Audio 12" with 2 15" PR's powered by 400W. Then I had Elliot from Zlaytron...
  14. DIY Subwoofers - General Discussion
    Many aeons ago, about the time SVS started becoming big news actually, I was already intrigued by the possibility of making a DIY sub based on the tube design and already had pretty much everything figured out with regards to driver, amp and enclosure selection (including having used a great...
1-14 of 14 Results
Top