Search Results for ‘nearfield’

I am selling a pair of the mint NHT SuperOne 2.1 sealed bookshelf speakers. They are best value in the under $500 segment. I am yet to find sealed speakers that sound so well without subwoofer in this size. 6.5" paper woofers do bring up bass a lot but stay coherent. I paid $310 for them. My...

I have a three way project on the go at the moment. I am using a WIN7 laptop, a Behringer UMC204 and a calibrated Dayton EMM-6 mic to take measurements. I have a crossover that pretty much lies smack in the middle of the nearfield to farfield transition (300-400hz). The woofer is the Dayton...

Perhaps someone can shed some light on this for me and hopefully it won't sound like a dumb question.... I have a three way design which involves an RS225-8 crossing over to a Scanspeak 10F-4 at a planned frequency of around 400hz-500hz. I am planning of doing near-field and far-field...

I'm trying to figure out some strange high frequency (>800Hz) waves in my room's SPL graph. In order to rule out the speakers, I did a nearfield measurement of my front left, and my center. I'm using a CSL calibrated U-Mik1 on a boom mic stand. Using the 0 degree narrow band cal file. The...

Hi, My goal is to build 2 sealed subs for a nearfield (3ft) desktop setup (planning to buy Behringer 2031As soon). SPL is not my concern(I guess 105-110 max dB should be more than enough), but wish to have flat response and very low THD levels upto 25/20 Hz. So want to do everything appropriate...

I'm nearly finished with my latest DIY project, which is two sets of mini monitors for HT use. I have taken some REW measurements to verify the design and so far everything is checking out great, but it would be helpful if I could get some verification on my measurements. The measurement setup...

Hi can someone please tell me the settings. Thanks in advance

Hi can someone please guide me to these measurements. Thanks in advance

Good morning I'm trying to use the following guides to get my system dialed in http://www.hifizine.com/2011/06/bass-integration-guide-part-1/ and http://www.hometheatershack.com/forums/rew-forum/6818-minimal-eq-target-levels-hard-knee-house-curve-long.html I'm using REW with the UMIK-1...

Please can someone guide me for Nearfield Measurements? I want to measure the speaker itself. The speakers are Energy Veritas 2.3i floorstanders. e.g. Do i measure the drivers seperately or as one? How far from the speaker do i measure? And anything else. Thanks in advance

I have a pair of Behringer 2030p truth monitors hanging around and was thinking of useing them for front hieght speakers. Being a nearfield monitor does anyone think this is a bad idea and why? Here are the...

Because of space constraints in my apartment it makes the most since to have my projector set up in the unusually large entrance/lobby. The front door is on the top of an L, and the bottom right of the L is the corridor leading to the other rooms. The entrance area is about 2.5 m x 3 m, with the...

I am building 2 giant sonotubes that will both be about 10-12 feet away in opposite corners on the same wall away from my seating area. I want to put a mid bass unit right behind my seat but need to delay it so I can set my receiver to account for the ones further away. Is there anything like...

Hi Guys, Im looking to use REW for evaluating a stereo system in a studio. I just did a bunch of tests and ran into some problems. First of all, target settings were set to sub woofer, so I guess that voids the tests, so no graphs psoted here! Secondly , I ran both speakers for the test...

Hi Guys, Im looking to use REW for evaluating a stereo system in a studio. I just did a bunch of tests and ran into some problems. First of all, target settings were set to sub woofer, so I guess that voids the tests, so no graphs psoted here! Secondly , I ran both speakers for the test...

This thread is for all discussion of the Nearfield Monitor build found on AV Sound Lab.

Bored, thought I'd share some nearfield measurements of my 12" sealed sub ~2.0Ft^3 enclosure with about 3/4lb acousta-stuff Rythmik Direcservo (Rythmik Ds12tc driver w/ 350watt amp) Here is a shot of how I took my measurements. Results are below Red 28hz Setting Green 20hz Setting Blue 14hz...