Home Theater Forum and Systems banner
needed
41-60 of 342 Results
  1. DIY Subwoofers - General Discussion
    Hi, Can anyone help me with designing the box for "Dayton Audio RSS315HF-4" 12" subwoofer with "Bash 300S" plate amplifier. This is my first sub build and I am not sure what to expect. I will be using it for 30% music and 70% movie. I have seen few designs for this but not sure which one to...
  2. Home Theater System Recommendations
    I’m pre-wired in a large room for a 9.2 system. Initially I was thinking about just buying a 9.1 AVR and be done with it, but I may or may never add rears or highs/wides but then again, who knows? So if I start with a good 5.1 AVR ($1000) range I'm assuming it would it be possible to add...
  3. Home Audio Acoustics
    Hello Enthusiasts! I've had a HT in my walkout level for 15 years. Over Xmas vacn I've been adding some cabinets, relocating electronics, moving closets, etc. I'm almost done but am trying to figure out how to suppress the HVAC noise I've exposed by opening up a new under stairs storage area...
  4. Home Audio Speakers
    Hey yall, I have a buddy thats just beginning to put his system together. His current plan is to get a receiver and 2 towers and piece the rest of it together as he goes. Its looking like the Denon X2000 from accessories4less is going to be the choice for a receiver. That leaves us with...
  5. REW Forum
    I am trying to use REW and I have read the instructions, help quides, FAQ's, various REW help threads etc for hours and I am stuck. I am using a radio shack analog SPL meter. I don't have a microphone. Anyways, I have my SPL meter hooked up by a RCA cable to a 1/8 inch adapter to my laptop line...
  6. Home Theater Projectors
    So after a long time researching I finally got my W1070, 3d Glasses and screen. Sadly things are not good. I connected my new HDMI cable to the mini HDMI adapter that connects to my HTPC (GTX460) and it never finds the signal, not even during Bios boot. This same adapter I have been using with...
  7. System Setup and Connection
    I am setting up my projector and will be running an HDMI cord but would like some help determining if I should use a "signal extender". The run will be approximately 30'-35'. Has anyone ever used an HDMI signal for this long a run from AV Receiver to HDTV? In my current home...
  8. DIY Screens
    Hi all, First let me introduce myself. I am Mark and I live in The Netherlands. A few weeks ago I bought a projector (Optoma GT1070x short throw) and a standard white screen, also from Optoma. While this performs nicely in the evening with no ambient light, the screen looks dull during the...
  9. Home Theater Receivers | Processors | Amps
    I am upgrading the basement theatre and looking to get a Dolby Atmos supported pre processor to match my configuration looking to see anyone had experience on comparing Yamaha RX-A3040 VS Marantz AV7702.. I've never owned either brand AV gear so appreciate experts advice about how they (at...
  10. Sealed Subwoofer Build Projects
    Ok, wanting to build a DIY subwoofer in a small form factor and use a miniDSP to EQ it. I want it to be clean, tight base. Driver needs to be able to play flat to 20hz with eq, output level should be min near 110db or higher. Is this possible with a $500 driver and if so what drivers should I...
  11. Home Theater Room Photos (Finished Rooms Only)
    I have owned some NHT speakers, AV Receiver and Power Amp. not long ago, need advisory,ideas or any opinion and suggestion for the best setup from members 6 x NHT Absolute Zero bookshelf 2 x NHT Classic Three bookshelf 2 x NHT VT1.2 floor stand 1 x NHT Absolute Centre 1 x NHT VS1.2 Centre 1...
  12. DIY Subwoofers - General Discussion
    Hello, as a first build, I would like to put together a subwoofer. I came accross 2 good looking CV subs, but cannot find any information about them needed to calculate the box size. Do you guys have any idea where I can find this? I tried asking it to Cerwin directly, but no response. Google...
  13. System Setup and Connection
    I'm planning to go from 5.1 to 7.1 Room is 3,1 wide and 5m long Left side is under roof. The roof begins at 1m height Fronts are focal 826v Center focal 800c Rears now are focal 806V What should i buy for my 7.1? Focal sr700 or focal sr800 (bipoles) Where should i put the bipoles? Next to...
  14. Home Theater Receivers | Processors | Amps
    This may not be allowed here but my frustrations has led me here. After problems with my onkyo tx-nr809 with no sound I had to send the unit to Onkyo for repair. I just got it back, hooked it up, run calibration on it to set the speakers only to have the receive shutdown. Now all I get is the...
  15. DIY Audio
    I am looking to replace my B&W 683 LR and B&W VM1 Center with a DIY setup in the quest of getting greater sound output and clearer dialog. the VM1 is extremely challenged and to be honest I only have it as it is easily mounted to the wall since I do not have anywhere else to put it. I...
  16. Remotes | Cables | Accessories | Tweaks
    Hi Guys, I have a question about controlling a pretty specific device with my Logitech Harmony ultimate: I have a special so-called 'auto-masking' home theater screen. This is a screen which can be automatically (electrically) adjusted to custom pre-defined screen image height. My screen...
  17. DIY Subwoofers - General Discussion
    I'm working on planning/modeling the subs for my living room theater and am looking for some input. I have approximately 28cf of volume to play with, I also have 400wpc (@3ohm) and up to 6 channels of power on hand. This will be mostly for theater use. The only requests from my wife is that...
  18. DIY Repair and Maintenance
    Hey Everyone - First time poster here. One of my older TV's has stopped working and I really don't want to replace it. It's a great spare TV. Samsung hl-r4667w. When I turn it on, the picture comes on and then the screen will go black. A few moments later the screen will come back, and...
  19. DIY Subwoofers - General Discussion
    I want to build a sub to cover the two octaves from 8 to 32 Hz. For context, my 2 channel system comprises: one Electrovoice EVX-180B ported per side, each running off its own bridged QSC PLX3102, one 18Sound 10MB600 in a ported chamber per side, each running off one channel of a QSC PLX2502...
  20. Home Theater System Recommendations
    Hello all, first and foremost thank you in advance for any help you guys give. I've come here before for help and you guys are always awesome. I had a Onkyo RC360 AVR which just stopped outputting sound a few weeks after the 2 year warranty ended. Given that this is my second broken Onkyo I'm...
41-60 of 342 Results
Top