Search Results for ‘procedure’

First off, I'm not even sure I need to ask the questions that appear below. I think the purpose of time-aligning a sub is to smooth out the frequency response in the crossover region. I also think that auto EQ like Audyssey and Dirac do this for you. But if using REW, I think it's a manual...

To Whom it may Interest: I am a dedicated audiophile/stereo-phile, with reasonably capable electronics/speakers, however, I have never elected to take the time to properly set-up/"tune" my system other than by ear...and now wish to get more precise in terms of listening position frequency...

Since getting hooked on all the amazing sub build threads here, I've tried to slowly acquire a 'procedure', if you will, of how to successfully build a HT-oriented ported sub from info found here and all over the interwebs. I figured I would put this out here and hopefully get more or less a...

I've been trying to set up REW with a dB meter from RadioShack. I've calibrated the soundcard. When I do the "Check Levels" I get a humming/buzzing noise from my speaker together with the test sound. I have connected: - Line-Out (PC) to an RCA-input on my receiver - Line-IN (PC) to the...

New Guy and First time poster but long time reader. Input conditions to help understand my question. I'm using an Cross-Spectrum Labs calibrated Behringer ECM8000 mic and Xenyx 802 preamp as recommended with Kimber Select cabling for connections to a HT/Omega Claro Halo sound card. While making...

Hi guys, I used to use Radio Shack SPL meter in the test. Each time before I start the tests, I will do the SPL calibration as instructed. Recently, I retired my Radio Shack SPL meter and replaced it with the ECM8000. The new setup works pretty well, but how should I run the SPL calibration...

Hi I was wondering what others are doing as a sequence to arrange their subs, running REW as an aid. I have two home made sealed subwoofers with 10" drivers. Both subs are 4 ohm ran by one channel of an older Yamaha natural sound amp which rating is 115WPC. Impedence on the amp is for 8 ohm so...

I have a Toshiba DLP 52HM84 and I was wondering about if anybody else owns one and when you turn the tv off does the lamp go into a cool down mode or does the lamp turn off right away. Because my tv when i shut it off the lamp would still be on but go off after a few minutes letting the lamp...

Being new to this world I've a question on procedure. I'm currently trying to master the basics of repeatable results so, here is the question: Simply running pink noise I've set my RS meter to read 75db and without logging any freq. results and after playing with the eq (adjusting the bands at...