Search Results for ‘range’

I am contemplating building a ported box (7-10 cu. ft.) using the Dayton RSS390HF-4 15" driver. Goal is to run from 20hz-300hz so the box can be used with various Oris horns than can go down to 150hz-250hz. I would really like a LF section that could cover the 20hz-300hz range. Anybody have...

As many have said before me the knowledge on this web site is fantastic and I have read with interest and put into practice lots of the techniques I have seen online, house curve, min number of filters etc ... However, there is one area which appears not be to addressed and that is Full Range...

When it comes to speakers matching timbre with each other and using REW to look at the frequency plots, what is an acceptable deviation from 250Hz-20KHz between each speaker?:dontknow: Not necessarily to a perfectly flat response,but to where the speakers seem to blend with each other...

"Open Range" DTS-ES 1. Opening Rolling Thunder, Chap 1 (0:02:43) 2. Shootout, Chap 14 (1:42:59) 3. Shootout, Chap 14 (1:44:32) 4. Shootout, Chap 14 (1:46:53) 5. Shootout, Chap 15 (1:51:23) 6. Shootout, Chap 15 (1:55:46)

In most consumer products you get a function of value per dollar having a high slope at the bottom of the price range (much more value per dollar for every more dollar spent on the margin) to a point of inflection where the marginal dollar buys less and less until it comes to the luxury level...

So I've been dealing with the floor-standing center speaker dilemma, and I was wondering if anyone has simply taken a floor-stander and modified it to fit sideways or even put the guts into a DIY cabinet that's shorter or even horizontal. Mine have a tweeter, a 5" and two 8" drivers... what if I...

At the present time, with more time, on my hands I’m dealing with the matching LCR yet again with the two subs playing the same range in the low end department 15Hz while the remain frequency response sweeps though up to 16,000kHz. So far applied a frequency cut on the left channel as it was a...

Hi guys, I know this might be a little below your preference, but I was wondering what opinions there were for other speakers in the price range of the Rocket 450's (<$600/pr). Talking towers right now. I listened to 450's (and for comparison, 760's but not 850's) over at 45minaudio's shop...

I am modeling a small sealed sub that would fit inside my Ikea Expedit bookcase. The hole is 13.25"x13.25" I already have 1 Dayton DVC 10" driver so I figured I'd pick another one up. Not the idea drivers but a neat little experiment non the less. I was researching building an LT for this...

Hi all, I want to attempt to calibrate my main speakers this time around. I had successfully calibrated my sub (flat to 13hz) about 2.5 years ago. I've just did some reading these last few days and decided to use REW to calibrate my main speakers this time. I understand that I need some...

Couple of quick questions from a new user (me). :dumbcrazy: I plan on using the DBX mic for full 20Hz to 20KHz measurements, and I'd like to know if the mic is to be used with the tip pointed to the ceiling or at the speaker. I'd also like to do some averaging of the responses taken in a 3...

I'm reading through here to get some tips and ideas on how to possibly integrate the BFD into my budget HT setup...and most of the descriptions and guides here seem biased to bass management. Is there a reason why people wouldn't be using the BFD for full spectrum EQ? I ask, because I have...

I was wondering, if I had speakers for my mains that topped out at 16khz what or how much would I miss from mains that would go to 20khz. Would it be profound or barley missed. Also I am 51 and I don't know what if any difference that would make in hearing different frequency's. THANKS.......

Hi all, I have just ordered a PB13 Ultra. I expect I will have some REW and Behringer related questions for you later. For now my query is related to the Galaxy. There probably is an easy answer but it doesn't make sense to me as I have no idea how this all works apart from trying to follow...

Folks I am about to admit defeat. My room acoustics are not the best but, I have to say I thoroughly disappointed with my setup. I seem to have no luck what so ever at integrating a sub with non-full range towers. Mythos Ones and a Supercube I just do not seem to want to marry. At least for what...

I have been playing with REW for a while, and have been less than impressed with my graphs as a result of the auto EQ feature on my AVR635. I did a firmware upgrade today through the RS232 port and now I have a sweet balanced machine as the following graphs should show. Apart from that obvious...

Has anyone tried using amps that are traditionally considered "subwoofer amps" for full range (LCR and/or surrounds)? There seems to be a lot of bang-for-the-buck in amps like the Behringer EP1500/2500's. I could envision 2 of 'em running LCR and sub, but don't know how they'd do. The...

Newbie. Fast Track Pro or E-MU 0404? or other USB external sound in $200 range? I'm getting ready to finally buy some "real" sub-woofers, and I want to be able to properly calibrate/tune/adjust them as best I can. For many years, I've had a Radio Shack Sound Level Meter- Model Number 33-2050...

Hi there, here i intend to post my experiences about full range eq corrections on my system using REW. I' discovered this great tool a few weeks ago, after trying to get the best from a DEQ24ç6 i recently bought. After some testing and auto eq, i realized that i needed to get more informations...