Home Theater Forum and Systems banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 37 Results
  1. Ported Subwoofer Build Projects
    Hello, I currently have a B-2 active bass extension & subsonic with a crown pro amp. I’m looking to find a replacement. What is everyone using?
  2. Subwoofer Amps | High Pass Filters
    Good evening I am about to start a DIY sub project with the mach5 IXL15.2.2 in a 5 CF box tuned to 20,74 Hz driven by the EP4000 and i need tHPF at 17 Hz according to the gentlemen who design the sub for me. Since the Reckhorn B2 seems to be unavailable would the EQ.2 from elemental Design...
  3. Classifieds - Equalization & Calibration Equipment
    http://www.reckhorn.com/index.php?ln=en&prod=b2 Mint & hardly used. $80.00 CDN shipped to Canada, USA. Thx Jeff
  4. Subwoofer Amps | High Pass Filters
    Does anyone here use the reckhorn s-1 for their sub? I was thinking about using it for an ep4000 and tempest-x II sub as it has both high pass and low pass (high cut). Thanks, Sam
  5. DIY Subwoofers - General Discussion
    Hello I'm trying to find out where and which type of Reckhorn I should get. The only one I can find is the Reckhorn S-1 Subwoofer control with Satellite crossover on ebay for 95 dollars. Will that one work? I think I'm getting a Crown XLS 1000. will that be a good setup? I'm getting my subwoofer...
  6. Home Theater Receivers | Processors | Amps
    I have a Ep2500 and a DSP1124 that will be powering my two subs. I need to boost my signal from my Onkyo 804 to match that of the ep2500, Which would be better for this application? the S-convert or the B-1? thanks Pete
  7. Classifieds - Audio Equipment
    This is fan modded and is in mint condition. Great piece. Never caused any problems, never clipped. SOLD (see below) Do not have box. Buyer pays shipping - I will have it shipped the best I can but I will not send a refund until a career refund is sent to me if it is damaged (will be packaged...
  8. Subwoofer Amps | High Pass Filters
    Would a reckhorn b-1 be a good choice for a stereo 13hz hpf? Its one of the cheaper hpf with a right and left input and output. I notice some eq/hpf have left and right input, but mono output. My onkyo tx-nr1007 has the .2 option and I would like to keep that fuction.
  9. Classifieds - Equalization & Calibration Equipment
    Hey everyone, I'm wanting to buy a used reckhorn b-1 or b-2. I'm all about buying used stuff. Thanks, Andrew
  10. Subwoofer Amps | High Pass Filters
    I have just finished building 2 15" Dayton Titanics with 18" passive radiators in sono tubes for H/T use and was wondering what others who use the Reckhorn B-1 have their units set to as far as boost level and boost frequency? I use a Behringer EP-4000 for amplification, and have the subsonic...
  11. Subwoofer Amps | High Pass Filters
    Reckhorn's website says they are sold out. Where can I still find a B-1? Maybe someone has a used one that you don't need? Thank you.
  12. Subwoofer Amps | High Pass Filters
    I recently built my first diy sub. I have a Mal-x in a pr'd 8 cubic foot enclosure tuned ~17.5hz. My receiver is a Pioneer elite vsx-21txh and my amp is a beringer EP4000. When I connect the Pioneer directly to the EP4000 and run MCACC everything works great. The sub sounds pretty good and...
  13. Two Channel Audio
    This is post that I attached to the original brucek post about his modifications. Nobody has answered or commented, so I will try my luck with a new post. Hello, I am new to the forum and was wondering if someone could help me with some questions. All answers are greatly appreciated. I am...
  14. Subwoofer Amps | High Pass Filters
    Hi there, I want to buy an hpf this week but am torn between the two. I have also looked at the Behringer DCX2496. I am looking for some advice. Would the DCX2496 replace my current BFD so that I can just use one device. It is more expensive than the two others mentioned but is it worth the...
  15. System Setup and Connection
    I am adding reckhorn B2 to my DSP1124, should I add it before or after the DSP1124? This is mainly only for the HPF.. I don't think I would use the boost functions as the DSP1124 already does that. I plan to use a pro amp after DSP1124, will the reckhorn help with the level conversions? Also...
  16. Subwoofer Amps | High Pass Filters
    I've read a few posts questioning the accuracy of the B-1 but it seems to be all opinions rather than measurements. Can anyone add some clarity about whether there really is an issue with the B-1 as a sub crossover? If there is an accuracy issue, what functions are affected and how far off is...
  17. Classifieds - Equalization & Calibration Equipment
    Hey, Lightly used Reckhorn B-1 for about 3 months. Bought it new from Creative sound solutions over the summer. Still have original everything. Unit is in great shape cosmetically and mechanically. $80 shipped con-us :T I'm currently located near Harrisburg, PA if anyone would like to pick...
  18. Electronic Processing/Equalization Devices
    Hi there, I will need to get some cables to connect my Reckhorn B2 to my BFD. Do I need to get expensive cables or will cheap ones do. I presume I need one rca male to 1/4 jack male to go from the reckhorn to the bfd and then get a rca splitter (I have some 1/4 jack adapters) to split the...
  19. Subwoofer Amps | High Pass Filters
    Aside from my thread there have been at least 2 others recently inquiring about the line level effect the Reckhorn B-1 has and if it is truly a signal boost or an attenuator. Some facts (more like speculations) that lead to this: 1. The reckhorns manual claims it has a 10v output. This is not...
  20. Subwoofer Amps | High Pass Filters
    Balancing gain in: Receiver, Reckhorn b-1 and 2 x ep2500 EDIT I am switching to an ep2500 and an ep4000 both in bridged 4ohm and needing to put out about 1100w each for my subs. Since the gain on these is only 1.23v will the reckhorn b-1 be enough? What does the reckhorn mean when it says it...
1-20 of 37 Results