Home Theater Forum and Systems banner

relative

  1. Relative mode

    Mobile Audio
    Is there a way to measure one side, set that measurement as a relative mode (zero reference) and measure the other side? Thanks, Kevin
  2. Feature Request: Relative data

    REW Forum
    Scenario: make a measurement - select this measurement as reference data - make modification and another measurement - select second measurement as comparison data - execute relative comparison - output data view to show difference of comparison to reference data - will be shown as relative...
  3. Relative phase of dual subs...?

    REW Forum
    Hi guys, I want to make sure that what I am telling a friend is correct, so I am running it past the experts (you all). He is the new owner of dual SVS subs which he got used, and proceeded to hook them into his system. After a great deal of testing, they were not giving him the "oomph" he...
  4. Abolute vs. Relative

    Home Theater Receivers | Processors | Amps
    Hey folks I'm kind of confused l have on Onkyo tx- nr708 110 watts 7.2 Ever since l have had it l have the volume setting at the absolute setting with the maximum level output being 99 When l watch movies l have my volume at about the 35.to 40 range my speakers are fully capable of handling the...
  5. Relative or Absolute?

    AV Home Theater
    Hello, I have a rather simple question, what is the difference in Absolute and Relative volume settings, I noticed most if not all refer to the volume levels as Relative settings -dB as opposed to +dB. I hope I am not showing my ignorance here with this question. Thanks. Jeff
  6. relative newbie

    New Member Introductions
    Hello all! I'm relatively new to this site, but have enjoyed playing around some with the REW software for a little while. Unfortunately I caught the home theater and car audio bug. I enjoy trying to figure out how to improve the quality of my systems without blowing a hole in my bank...
  7. Levels not set correctly relative to what is needed for measurement

    REW Forum
    I have done all my single driver measurements and was moving on to a left mains + subs measurement. I have properly set level and calibrated the SPL meter in REW. The results I get when taking a measurement are different based on what I use to set the level: Use Main Speaker to Check/Set...
  8. Relative Power in Audio Spectrum

    DIY Speakers
    I’m interested in speaker design and construction. One of the design decisions that must be made is determining the power rating of each driver in a multi-driver system. Anybody know if there is an available study that shows the typical relative power contained in each segment (1/2 octave, 1/3...
  9. Tuning a port relative to fill

    DIY Subwoofers - General Discussion
    If for example i had a 200l box and was able to squeeze another "40l" out of it with fill, do i tune the port to work for a 200l or 240l box?
  10. use of pink noise generator to check relative channel levels

    REW Forum
    This is probably a silly question, but if I play the pink noise through the system the 'image' should be dead centre, is that correct? The reason I'm a little confused is that from memory the signal is only on one channel out (which is why we need a stereo jack to ensure correct contact), would...
Top