Search Results for ‘remove’

Hi, After upgrading to REW 5.19 beta4 it appears that loading previous measurements, then trying to remove all of them does not work anymore. After downgrading to REW 5.19 beta3 it works again. Regards.

Hello I use REW 5.16 and I've got a problem, when I make a new measurement I don't have the button " change cal.." in the measurement panel,,,, is there an issue ? thanx a lot

Hi, Could anyone please advise if I should use the REW feature under the estimate IR delay tab that will shift the IR so the highest peak is aligned to time = zero, before I create my EQ filters? I am trying to create an IR EQ filter for some nearfield studio monitors. Am using one channel of...

Hi guys, What do you guys use to clean dust/fingerprints, etc. from your hdtv screens? I have a Samsung LED and want to do some cleaning on the glass. I went to Amazon and see the "MagicFiber® Premium Microfiber Cleaning Cloths - For Tablet, Cell Phone, Laptop, LCD TV Screens and Any Other...

I started my coolant change on a 10 year old Philips set. I've read alot on this and other forums as well as my Service Manual. I pulled the back panel and started to remove the blue gun first. I could not figure out how to get the HV wire out of the splitter. The wire has a black clip...

I have read the section how to repair convergence problem of the Mitsubishi model WS-55511. I found a 15AMP pico fuse open. I need to replace a fuse and convergence IC, I ordered and received all the parts (IC from SANYO). My problem is the ribbon cables, How can I safely remove thoses cable so...

Hi, I have a Pioneer PRO610HD, which is awaiting new STK chips. I want to pull & check the HV deflection board for bad solder, while I have the set apart. Is there some sort of trick involved (a tool perhaps) in removing the CRT anode leads from the HV distribution block? These seem to be in...

i have a WT-46805 mitsubishi 46" RPTV i had the convergence issue for a short time and then my TV simply stopped turning on. i diagnosed the error using the menu/input method and got a 2 - 2 error. after researching online i found that the standard cause for this error would be one or both pico...

Hi all - just got finished using REW w/ BFD to eq my sub with my new Yamaha RX-V1800 receiver. Overall I feel the calibration went excellent. However I have one nagging issue I can't tame that I'd like your feedback on please... I use a house curve of 20 8.0, 80 0.0 and obtained a nice smooth...