Home Theater Forum and Systems banner

responce

  1. Is denon altering my bass responce?

    Audio Processing
    Hi all, Hopefully this is the right place to post this. Ive recently got a some new mains and a new receiver, switched from a 2600 to a denon x4300h so Im still figuring out denons way of doing things. Im having a hard time integrating my sub into the system with good results. Sadly I have 2...
  2. Optimized impulse responce of subwoofer; Horn VS Vented box

    DIY Subwoofers - General Discussion
    Hi, I am investigating how to get best possible impulse response from a sub that will go all the way or close to 20Hz. Ideally I want to play 20Hz square-wave and it will still look as a square-wave when I measure it with a good microphone. My first approach was that a horn loudspeaker would be...
  3. converting audio files to match room responce

    Electronic Processing/Equalization Devices
    Hi, I own a vintage stereo receiver and a CD player. I recently purchased a miniDSP and a UMIK-1 to try to improve my audio experience. The problem is that miniDSP has too few filters for my room to be adequately corrected. Is there a computer program that could transform a ripped cd file by...
  4. Bad frequency responce with REW

    REW Forum
    Using REW I am getting a sharp drop-off below 100 Hz. This is direct wired to sound card, no equalizer in system. Other software shows a good response with same setup. Does any one have any ideas?
  5. Want super low freq responce & lots of output. Advise?

    DIY Subwoofers - General Discussion
    I am new to the Diy game and am looking for suggestions on building a good ported sub to be used in my hometheater. I am sort of handy with tools and feel pretty confident in my skills. I do not have any experience with design software and honestly don't know where to start in terms of learning...
  6. macbook pro + RME FF400, false levels, responce not where it sould be

    REW Forum
    Hi Folks! When trying to set up REW on my macbook pro with RME FIreface 400 i noticed that the input levels i get in rew are much lower than what i see on the FF400 mixer. If i see -25db in the mixer rew is only hearing at -63db... Also, if i do a measurement REW is telling me that the input...
  7. WinISD plots : default auto-flatest responce

    DIY Subwoofers - General Discussion
    What are the pros/cons of simply using the default plot WinISD gives for a particular driver in a particular alignment. Please, for now, ignore room gain as well as room peaks and nodes
  8. what am I missing for impulse responce?

    REW Forum
    This is going to be one of those dumb questions. I’m sure the help files tell how to do this and I’m just not comprehending it. I’m trying to do an impulse response with rew and I’m missing something. Shouldn’t the sweep produce that loud click noise? Is there a pull down menu option that I’m...
Top