Search Results for ‘rms’

I plan on going 4.00 cf gross for the pyle sub sealed this gives it a center frequency of about 35 hz and a -3 at 27 hz. We could even stuff it for an even lower center frequency and lower qtc than 1.10. The subwoofer is dual 4 ohm so we would need a amp at 200 rms at 8 ohms. Any suggestions...

could i use the crown 1502 to safely drive a single duel 4ohm sub with an rms of 500watts [250 per coil] wired to 2ohms (one on the left an one on the right channel) an feed each 775watts my woofers is the Audiopipe 15" TS-CVR 4-ohm DVC without burning them out i think it would be 137.5watts...

Hi! Im planning to buy inuke nu3000(dsp) or nu6000 to power my single 12" 1500w rms subwoofer. So the question is does nu3000 give enough power? Does it give 1500w rms or what is the irl (In real life) power? If nu3000 doesnt give 1500w rms or more i have to think of buying nu6000. I dont want...

Does anybody have an opinion or experience with either or both of the following drivers for use in a 2 way speaker system: ` 1) Woofer, beyma 10" model number 10BR60V2 ` 2) Tweeter, Tang Band TW series 28-537SH ` In reading the data sheets and analyzing the frequency response curves and...

Hi Everyone ... I need a recommendation for a True RMS AC multimeter and a reasonable price. Thnx

Hi everybody noob question, but when modeling in fx winisd, should you input the amps rms watts or peak (I'm thinking in regards to avoiding exceeding x-mas of the driver?