rp

Hi folks. I'm a new guy and just need some repair help with a rear projection set that lost the picture. I just replaced both STK392-110 chips on a Toshiba TP55E81 rear projection set that lost the picture. I ordered the chips for $21.95 from electronic-repair-kits because they say they only...

I have put my Klipsch floorstandings and center to 80hz in my amp so the sub takes over all the low beneath 80hz, right? But if the sub isn't on because it doesn't get a signal and if I'm listening music on a low volume will then the sounds below 80hz taken by the floorstands or not? I mean you...

I am considering getting a used RP TV to cut into four pieces to use with three of my projectors (no i am NOT rich, I bought them for $80 each :P ) I wanted to know if projecting onto these from directly behind would work or if the screens only work when projected onto at an extreme angle? TYVM

I have noted that many people have had repeated problems with convergence amp failures on CRT based RP sets. I also see people who DIY having problems completing the repair correctly. This thread is about the former. Even many techs seem to not understand what makes these circuits fail, so...

I have a Sony KF-42WE610 LCD projection TV. Recently the picture has developed a blue haze in the middle of the screen with blue spots at the top. After doing a little research I found that it is the optical block going bad and that this is a very common problem. Sony recognizes that the optical...

New models have started to hit the stores. The models that we know about are listed here. We will post info as I get it, but only after I confirm it. The last introduction of sets involved a great deal of confusion regarding differences between the models. We will try to keep the information...