Home Theater Forum and Systems banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 13 Results
  1. REW Forum
    Although I had successfully measured amplifer distortion at the loundspeaker terminals, when I did this a second time I managed to damage my inbuilt PC sound card. I was not using a voltage divider probe since I knew the AC levels were no more than 250mV. I don't fully understand what went...
  2. DIY Speakers
    Hi, eveyone? Please help me with this. I have the behringer amp 3000dsp which handle a 8, 4 and 2 ohm load. I want to connect two speakers in parallel, one is 8 ohm and the other one is 4 which will make a load of 2ohm. The reason why I want to run them at two ohm is because if I wire them in...
  3. System Setup and Connection
    I am going to use Polk RTIA1 speakers behind my couch in my 5.1 audio setup. Do to limited placement ability I am unable to do 7.1 This also means that the speaker behind the couch would be hooked up to the receiver on the surround channels and not the rear channels, technically acting as...
  4. Subwoofer Amps | High Pass Filters
    Per the title... I have four Stereo Integrity HT 18 D4 for IB install via two manifolds. How much RMS power can each driver "safely" handle (using both voice coils)? Estimates are okay! OR... What is an acceptable rule-of-thumb regarding "rated specs" (which are probably assuming enclosed) vs...
  5. Home Audio Acoustics
    I recently built a 5 cubic foot sealed 18" sub, and am nearly finished a second identical subwoofer. The finished sub is in the back right of my room, and I am considering placing the second one in the front left, between my center speaker and the left tower to balance out the sound. For...
  6. Home Theater Receivers | Processors | Amps
    I have a MiniDSP I want to use to EQ my sub. It's the unbalanced 2x4 (I should have researched just a little more and bought the balanced version). I don't know yet because I haven't had a scope on it but reading around the net leads me to believe that my sub out on my AVR (new Pio. SC-71) may...
  7. Official DVD and Blu-ray Reviews
    http://www.hometheatershack.com/gallery/file.php?n=9212 Title: Safe Starring: Jason Statham, Catherine Chan, James Hong Directed by: Boaz Yakin Written by: Boaz Yakin Studio: Lionsgate Rated: R Runtime: 94 minutes Blu-Ray Release Date: September 4th, 2012 Movie: :4stars: Video: :4.5stars...
  8. Home Audio Acoustics
    Hi everyone, I am finishing my basement and 1 of the room will be my own personnal HT (HD Projector, 120 inch Screen, Onkyo 708, 5.1 speaker system (not purchased yet). Since my ceiling is not yet completed, i was thinking of putting Roxul Safe N Sound on my ceilling. Since they are 3 inch...
  9. Home Audio Acoustics
    I found mineral wool by Ruxul, Ruxul Safe, not Safe 'n' Sound, in a local store. 85 cents per square foot. It's 4 x 24 x 48 in., 4.5 lbs psf, NRC 1.10 Acoustic performance at 125, 250, 500, 1000, 2000, 4000 Hz is: 1.03, 1.07, 1.12, 1.04, 1.07, 1.08 respectively. Is this good for bass traps...
  10. Home Audio Acoustics
    It looks like Roxul Safe n Sound is only available in Canada. What is a comparable product in the US? Or is 'pink stuff' with double drywall good enough. This is for a basement HT. Thanks.
1-10 of 13 Results
Top