Search Results for ‘screws’

Good afternoon Anyone could help me and point me in the right direction I am looking for replacement screws for the EP4000 chassis, I called a few Behringer dealer none has that listed as a part , went to my local reno depot did not have that kind of screws Thank you for your help Alain

Hi everyone, I want to ceiling mount my projector (Optoma H180x, using this mount) Problem: screws supplied with mount do fit the projector, but the projector's screw thread are pretty small (like, 5 millilmeters!) whereas the screws are more than 1 centimeter long. As a result, there are...

Hi everyone, I realize my ceiling beams are too thin to receive the 4 screws necessary to attach my ceiling mount. The only way would be, not to install it so that the square of the mount basis be parallel to the projection screen, but rather diagonally with an angle of 45 degrees (so that one...

Hey all, I'm in the cabinet design phase for a SI HT 18 I pre-ordered yesterday. Its going in a sealed box. Im planning on a thick baffle, at least double thick maybe thicker. Im using MDF throughout but have been reading some comments on the use of t-nuts and bolts for the driver. I have used...

I've never used Green Glue before, I understand (or do I) it is not actually a glue, and that you screw the panels together. In a ceiling application, do the screws in the panel facing the interior need to go into the furring/joists for support, or just a good ways into the first sheet...

#8 or #6?

The hole at the front of the SDX-15 will accomodate a 1/4"-20 screw. Unfortunately the edge of the surround or a gasket is preventing the screw from going all the way thru the baffle. I tried putting some pressure on the screw but it would not go. The speaker is pretty heavy and 10-32 screws...