Home Theater Forum and Systems banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Home Theater Systems | Equipment
    First of all I'm not sure if I'm posting this is the correct area but it seemed as good a place as any. If it needs to be moved, please tell me. OK so I just finished building a passive sealed 18" sub and have speakon (twist connector) connectors between the amp and sub. My plan is to run...
  2. Sealed Subwoofer Build Projects
    So, I just finished two 4 cuft HST18 builds. I mounted the sub and pushed it in a bit to verify that the box is sealed. After being pushed the sub snaps back into place, no slow movement or anything, but I hear a force of air coming out of the unused connections of the 4 pole neutrik, no where...
  3. DIY Subwoofers - General Discussion
    Hi, I'm going to be connecting a crest prolite 3.0DSP amp in bridge mode, which on the back has a bridge output 1 + -1 to a sub cab wired for a 4ohm load. I bought a 12 ga cable with NL2FX connectors at both ends. I also bought a 4 pole plate connector to connect to the sub cab. Will the cable I...
  4. Subwoofer Amps | High Pass Filters
    Good evening Just want to confirm that in order to use an amp in bridge mode i need to rewire the speakon end that connect to the amp only or do i need to rewire both end of the cable ? Alain
  5. Pro Audio
    Hi everyone. I am having two custom boxes built for the Mach 5 FTW 21 drivers. However my question is to make them with 2 pin or 4 pin speakon connector plates? All of my speakon cables are 2 pin. And I've heard 4 pin speakon cables are rare. However, I've also heard 4 pin speakon connector...
  6. System Setup and Connection
    I am confused, what does the writing on the back mean? I have dual pole male to male speakon cables but there only seems to be one way they go in and lock into place. Am I missing something? Is all you have to do is just use channel one and change the switches to bridged and its done?
1-6 of 6 Results