Home Theater Forum and Systems banner

sw

  1. SW with squeaking and no sound issues.

    Home Audio Subwoofers
    I got a great deal on a Miller and Kreisel V-125 sub, with a Klipsch driver. With everything hooked up correctly, it has no sound. When I try to adjust the volume on the sub, it gets very loud and squeaks just like a mouse! So when I grab the volume knob and try moving it from side to side (not...
  2. Greetings from SW Florida US

    New Member Introductions
    I'm an old school, Hifi, Home Theater and PC lover and hope to share a common interest....
  3. What SW distance to choose in AVR?

    REW Forum
    When choosing SW locations another question came to mind when I was choosing from two different distance settings to make in the AVR. I tested different distance settings and landed on 2.7m or 5.2m and they are both good compromises between L and R for support in the XO frequency at 80Hz but...
  4. Matching 2 SW

    REW Forum
    Hello I have bought a second sub and used REW to adjust the delay on the closer sub (named sub 2). With my minidsp I put in a delay of 3.4ms on “sub 2” and that matches the real change in distance very close. Both subs are pointing in the same direction and “sub 2” is on the left side and “sub...
  5. Dayton dual 12" SW kit

    Home Audio Subwoofers
    Just ordered Dayton RS1202k dual 12" SW kit from PE. Hope it's impressive, this is my biggest investment yet for my HT and a MAJOR upgrade from sw's I have now.
  6. Have I measured SW timing correctly and is there room for improvement?

    REW Forum
    Hello, see my system and my room dimensions in my profile. I use Antimode to eq the sub. All measurements were taken with Antimode on. YPAO EQ the 5 channels only. Ypao filters was to flat. Distance from mains to MLCP= 2,70m; same from the center channel and the SW. Although YPAO set the same...
  7. Hello from SW France

    New Member Introductions
    Hello, I'm an ex BBC sound engineer who retired in 2006. I joined the forum in order to download the REW software to see if I can use it to "play" a little with the LF response in my lively listening room. I have a Bryston / Harbeth system with B&W powered subs and play CDs and Vinyl of a wide...
  8. New Guy from SW Washinton

    New Member Introductions
    Hello everyone, I am new here and new to posting and forums in general. My hopes here, with your help are two things. I have read a lot about REW and hope to use it in setting up a 2 channel listening space. Second I'd like to build speakers and use REW to test and tweak the end products. I...
  9. testing SW with panny DMP-BD55

    Blu-ray | DVD | Disc Media Players
    I noticed yesterday that my SW never came on while watching WWZ at a fairly high volume and usually helicopter scenes are pretty good for a decent base thump. My BD55 is connected to my Denon 3805 via 6 rca cables for 5.1. I have a Denon 5900 DVD player connected to the AVR via a Denon link...
  10. audio source sw fifteen amp.

    Subwoofer Amps | High Pass Filters
    So I know there are a lot of plate amp options but I am looking for a cheap but ok plate amp to power a old sub that I have had for a few years and the amp is now deceased with the last words of a constant 60hz hum at 200 watts. Im guessing that the power supply went bad with what I think is a...
  11. Need quick DIY screen help (SW paint sale ends tomorrow!)

    DIY Screens
    Hello everyone! Long time lurker here but just registered a few minutes ago, so this is my first real post. For well over a year I've been thinking about painting either my wall or some Sintra (Komatex) that I can obtain inexpensively through a friend who owns a sign shop. I noticed several...
  12. UMIK-1 and ARC 2 sw

    SPL Meters | Mic's | Calibration | Sound Cards
    I saw a thread about using ARC 2 mic with REW. I ask for something opposite, did somebody try (if possible) to use UMIK-1 with ARC 2 and if so, what results? Thanks in advance
  13. Help and advice for painted screen options (SW or BM preferably)

    DIY Screens
    Brand new at this and my eyeballs are bleeding after lurking on several HT boards out there, but I've settled on this place to get some information (thanks well in advance). I have my projector setup and for my first pass at this, I want to go with a painted screen. I'm thinking a gray screen...
  14. Nak what would your prodiction be for gain on sw and also glidden 450 diamond

    DIY Screens
    Nak what would your prediction be for gain on sw and also glidden 450 diamond Nak you've seen both side by side and you've done some comparisons between the two what would you think the gain is on each one just from a visual point of view. I might need to bring up my gain once I do 135". Going...
  15. hotspotting sw proclassic

    DIY Screens
    hey. need some help sorting out my diy screen issues. ive spent countless hours reading about all the options since i ordered my projector in dec. its an epson 1760w. i primed then painted a 97x48" hardboard with sherwin williams proclassic satin in unique gray. the best roller i could find was...
  16. Sand-loading of SW cabinet: good idea?

    Sealed Subwoofer Build Projects
    I've been slowly moving down this path, but moving nevertheless, and this forum has been great. A few months ago I had my head on building one TC Sounds LMS Ultra 5400 18" mega sub for my music only stereo, posted the question here, got great feedback and ended up going after 2x12" Rythmik DIY...
  17. hotspots and SW proclassic satin

    DIY Screens
    So, I played around with the SW proclassic satin extra white. First off, this is the best flowing water based paint I have ever seen. After a couple minutes from being rolled on some sintra boards, it flows out as well as any solvent based paint. It's really that good. Does anyone else get...
  18. Greetings from SW Ohio

    New Member Introductions
    Found your forum yesterday. Looks like a lot of great information here. thanks Frank Onkyo TX-SR805 Polk RTi6 Front speakers Polk CSi3 Center speaker Polk OWM3 Rear speakers Polk PSW404 Subwoofer Toshiba A35 HD DVD
  19. New Mic / Measurement SW from Parts Express

    SPL Meters | Mic's | Calibration | Sound Cards
    Not that I would move from REW, but the microphone looked interesting and it is pre-calibrated. http://www.parts-express.com/pe/showdetl.cfm?Partnumber=390-792&utm_source=Retail&utm_medium=Email_Newsletter&utm_content=390-792&utm_campaign=email031512 Anyone know anything about the mic? They...
  20. DIY Screen: Komatex and SW Unique Gray

    DIY Screens
    I thought this forum could use a DIY thread, so here goes. Komatex 6mm Sherwin Williams Unique Gray 48"x82" (~90" 16:9 screen) Couple questions. 1) Which side of the komatex should I paint on? 2) Do I need two coats? If yes, how long do I need to wait before painting the second coat? I'll...
Top