Home Theater Forum and Systems banner


  1. Need Part # Of Amp on/off switch

    DIY Repair and Maintenance
    Hi Guys, I am trying to determine the part Number for the On/Off Switch for my Buttkicker BKA-130 amp. I have the schematic and found the on/off switch in there but the number there does not seem to be associated with any switches I have looked for.. So here is the schematic for the BKA-130...
  2. Wanted HDMI Switch with SPDIF Out

    System Setup and Connection
    Well my pre-amp is pre-HDMI and I can't justify upgrading it. I'm looking to use a simple Apple TV or Raspberry Pi-3 as a media stream device replacing my bulky HTPC. Unfortunately digital audio is only out over HDMI. So I'm looking for recommendations on a 4x1 or 4x2 HDMI switch with optical...
  3. Signal invertor for power switch using 3.5mm audio jack switch

    Headphones | Head Gear
    I have a 3.5mm audio jack with a switch build in. When you plug a jack in the switch opens. I would love to use this build in switch as a power on switch for a small device so when i plug in a head phone jack it closes a circuit and powers on the device. I don't know how to use the open circuit...
  4. Rackmount Switch

    System Setup and Connection
    Came across this picture the other day on Audioholics. I have a similar setup, this one is much cleaner. I like the switch being used and would like to incorporate something like this. I'm currently using a Netgear R7000 as a bridge reflashed with Asus firmware. Any suggestions? Thanks
  5. sanway FP14000 dip switch setup question

    Home Theater Receivers | Processors | Amps
    Aloha everyone. I just got a question about the dip switches and limiters on a Sanway FP14000. I'm not sure what kind of switch setting I should be using and this amp manual in not very clear on the setup. Is there anyone that is knowledgeable on this product or have a good link? I have been all...
  6. Cable for 12v Trigger Switch

    Remotes | Cables | Accessories | Tweaks
    I have an amp separate from my home theater receiver that runs the left and right main speakers. It can be powered on by a 12v trigger. I once had it set up this way but I lost the cable. Question: I thought I remember the cable being a simple, one wire cable connected by rudimentary jacks...
  7. Recommend a dumb, dumb, dumb HDMI switch?

    Remotes | Cables | Accessories | Tweaks
    Every HDMI switch I have seen for sale has one or more "automatic" features whereby it will switch inputs on some condition. I don't want that. I want a switch with a minimum of three inputs that stays set to the input I choose on the remote, no matter what other inputs get plugged in, pulled...
  8. Dayton 1200 driver switch to NHT 1259

    Home Audio Subwoofers
    Please forgive me... I have sinned and broken all the rules. I know not what I'm doing. I purchased several weeks back a pair of Dayton 12" subs for the ridiculous price of $160 for BOTH after reading Jmans excellent review. They sound very good and I'm very pleased with them as they are...
  9. Gigabit switch speeds

    Computers | HTPC | Media Servers
    Can anyone explain why I am getting low speeds, and then spikes on my LAN? When I look at my transfer speed in Windows I am getting 10Mb/s average. I have a Cisco Business Gigabit switch. The data was going from my windows mapped NAS drive to a USB SSD. I know the first question you will ask is...
  10. HDMI splitter vs switch

    System Setup and Connection
    Hi all, Question. I have one 720P and 1080P (3) flat screens and (1) 1080P Panasonic projector. Currently have been using a JTech splitter without any issue for a year now. I do not want to down play the 1080P picture quality and was thinking of getting a switch instead to solve the problem...
  11. AB Switch with HDMI, Mac and 2 TVs

    System Setup and Connection
    I've been searching for a compatible unit to AB Switch with HDMI, Mac and 2 TVs. I hope the info below will suffice for answering question of "how to connect successfully." Here are the units: Setup: Originating output, MacMini, Processor is 2.6 GHz Intel Core i5 El Capitan up-to-date. TV1...
  12. HSU sub & Audyssey - Phase switch orientation?

    Audio Processing
    I set my sub up when I first got it for music... and what was best for it's still current location was the phase switch set to 180... I've ran Audyssey and haven't even bothered switching it back to 0 and was just reading some material that said to make sure the sub is set to 0. How important...
  13. Switch some absorbtion for diffusion?

    Home Audio Acoustics
    Hello guys After i have listened to this youtube clip i am thinking if it would be an improvement to change some of my absorbation panels for diffusion Currently i have basetraps/chunks in each conor, screen wall with absorbtion on it. Wall panels with 100mm rockwool/isolation material and a...
  14. HDMI switch with headphone jack?

    Remotes | Cables | Accessories | Tweaks
    Hi all im looking for a 3-5 port HDMI switch that has a headphone jack also needs to come with a remote for the switching any out there?
  15. Switch device?

    System Setup and Connection
    I got a new home theater system. Yamaha 3066 and Acoustimass 10. Works real well and for the price, it fits my needs When I put on the music, it plays real well too but I'd like to have it spread in different ways so it sounds better all around the place (I dont listen to music seated on my...
  16. Check what ports are in used on Cisco 3750 switch ?

    Electronic Processing/Equalization Devices
    How to check what ports are in used on cisco 3750 switch and decide to buy what ports are available to use ?
  17. FBQ1000 remote ON/OFF switch and mains hum

    Electronic Processing/Equalization Devices
    I've a FBQ1000 in my home theater installation for the sub. It works fine but since all my equipment is remote controlled except th FBQ, I wanted to use a remote controlled power switch to turn on and off the unit. The FBQ power switch left at the ON position and the remote controlled relay...
  18. Installing auto on/off switch for powered speaker

    Home Audio Speakers
    Hello, I wanted to reach out for some help to some seasoned DIY audio people. I have several 5" Monoprice powered monitors paired up with apple airport express' for a makeshift multi room system. It works perfectly as each book shelf speaker is independently powered for each small room, but...
  19. Auto on/off switch on active speakers

    DIY Audio
    Hello, I wanted to reach out for some help to some seasoned DIY audio people. I have several 5" Monoprice powered monitors paired up with apple airport express' for a makeshift multi room system. It works perfectly as each book shelf speaker is independently powered for each small room, but...
  20. Ethernet switch

    System Setup and Connection
    I am going to run an ethernet cable from my router to the Home Theater in the basement. I have 4 devices to connect now. I think I should get an 8 port switch. Will any switch work or does it need to be designed for Home Theater equipment? After looking at switches online, I don't see an input...