Hi, I have gained a ton of useful knowledge from this forum... so thanks! :D
I ordered some titanium dioxide powder from amazon and hope to do some experimenting with it. My question is - has anyone tried this before and what results if any?
Okey dokey. Thanks to a lot of great help, both here and at the "other" forum, I think I'm close to a solution for my needs. This is a niche screen for sure. I'd say for a 122" screen or smaller WA DW would be a of a lot easier. But for a white 123" to 138" screen size, with a bit of gain...
This is a Xover design for some drivers I have laying around from a fomer project, two Dayton RS150S-8 and the 1" Dayton titanium dome, DC25T-8. The baffle on the cab (built 5+ years ago) is 7.5"x24" The box is a little under 1cuft tuned to 45Hz, the speaker is intended for an active HPF to...
This is a Titanium Power APEX10 This one I will install im my car.
FS-32HZ
QMS-6.658
VAS-1.4 cu. ft
QTS-.6
Xmax (in) .45
SPL-88
Dual 4ohm VC
Would this 10 be good option for IB in the car? I have a Suzuki SX4 Sport sedan. The seats do not fold down and there is no ski pass. The rear speakers...
First, I would like to say a proper thank you to the HomeTheaterShack Community for teaching me how to utilize REW, which has worked wonderfully with my setup until one month ago.
I have successfully used this great program to calibrate my PB-13 twice so far. The first time was earlier this...
Hello and Happy Holidays.
Have for sale a TC-3000 15" driver by TC Sounds. This driver has a quad voice coil and the newer Titanium cone before TC Sounds switched to the AXIS line. As such, xmax is only 30 mm, compared to the original which had 34 mm. The driver has the high roll surround...