Home Theater Forum and Systems banner

toe

  1. Speaker Toe In

    REW Forum
    Hi is it possible to measure (with REW) toe in of a speaker without moving the speaker? Thank you
  2. Measure toe in - out

    System Setup and Connection
    Hi am trying to fine tune my system by toe in What is the best way to do this e.g. one speaker at a time, then combined etc. More toe in = not as much roll off in the high frequencies? My system lacks high frequencies, once I move them it is hard to get back to where they were Thanks in advance
  3. Dipping my toe in the water: please check my sound card cal

    REW Forum
    Hi there. I'm just starting out with REW and have just attempted to calibrate the sound card in my Mac Pro (mid 2010 running 10.7.5). The sound card calibration produced the following: while the result of a measurement with the cal file in place is shown below: I wanted to check the...
  4. M&K K5 toe in or mounted flat to the wall?

    System Setup and Connection
    Hi I have a small bedroom set up with 3 k5s and 2 k4s, i just wanted to know if anyone had ever used these small speakers and if they worked better with a bit of toe in? My room is about 10ft wide and 13ft long, i would have a play around myself but i have just got out of hospital and cant walk...
  5. Toe in explained

    System Setup and Connection
    Hello, Please forgive my ignorance of subject matter but I'm trying to set up my new mains, manual states to aim the tweeter at the listening spot, toe in between 5 and 10 degrees, could someone please explain how do you know what degree the speakers are at, for example how do you know if...
  6. Toe equipment

    Home Theater Systems | Equipment
    My equipment has about settled down... Sanyo PLV60-HT (1368x768 widescreen LCD) Yamaha NS-777 mains Paradigm CC-350 center Polk R55i surrounds Polk RC60i rear surrounds Pioneer VSXD814 receiver Behringer DSP1124P BFD Behringer EP2500 amp (for subwoofer) FicarAudio Q18 drivers- customized for...
  7. Toe's HT setup (work in progress)

    Home Theater Design and Construction
    http://farzanegan.org/ht Update- as of last night- I now have the two tempests wired to the EP2500 (not through the 1124). Next steps: getting a RS meter and getting this tuned. The bass from my IB is amazingly clear- but not.. loud. I'm going to be really curious how it specs.
Top