Home Theater Forum and Systems banner
trs
1-5 of 5 Results
  1. System Setup and Connection
    Hi, Very newbie question: I have a pair of new Mackie CR3s (came with a turn table) that I want to use as my surround rears with a Sony STR-DN1070. The back of the receiver look like this: https://images.crutchfieldonline.com/ImageHandler/trim/3000/1950/products/2016/16/158/g158STN1070-B-1.jpg...
  2. Home Theater Receivers | Processors | Amps
    I don't want a metal one, I want it in all plastic so I can still use my speakers. I am looking for an all plastic TRS 1/4" "dummy" headphone plug to stick in my Receivers to keep dust from contaminating the contacts. Does anyone know where I might find something like this?
  3. SPL Meters | Mic's | Calibration | Sound Cards
    I am preparing to purchase the following equipment to run REW and got a bit confused choosing some cables/adapters and hope somebody can answer some questions for me. Mic: Galaxy CM-140 meter from Cross Spectrum Soundcard/mic pre/phantom power: M-Audio MobilePre The Galaxy CM-140 manual...
  4. REW Forum
    I am having good luck getting through the REW manual calibration steps.... Vista on a notebook, maudio mobile pre-the new one. R/S analog SL Meter, Behringer ECM8000. To keep the variables (except the room) to a minimum while learning, I am using a single KRK rockit 5 monitor and the ECM8000...
  5. Electronic Processing/Equalization Devices
    I just received a BFD and built a Processor to BFD RCA to XLR cable and noticed the input levels to the BFD were very low (bypass switch blinking and operating level button on back pushed in). So using an RCA to RCA cable with phone (two conductor adapter) connection to check if there was a...
1-5 of 5 Results
Top